HW-SPAR3-SK-UNI-G Xilinx Inc, HW-SPAR3-SK-UNI-G Datasheet - Page 42

• Manufacturer Part Number: HW-SPAR3-SK-UNI-G
• Description: KIT STARTER SPARTAN-3
• Manufacturer: Xilinx Inc
• Series: Spartan-3r
• Type: FPGA Configurationr

Specifications of HW-SPAR3-SK-UNI-G

• Contents: Board, Cable, Software, Datasheets and User Manual
• For Use With/related Products: Spartan-3
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 122-1521

Parallel Cable IV/MultiPro Desktop Tool JTAG Header (J5)
42
R
The J7 header also supports the Xilinx Parallel Cable 3 (PC3) download/debugging cable
when using the flying leaders. Again, make sure that the signals at the end of the JTAG
cable align with the labels listed on the board.
Figure A-4
chain.
The J5 header, shown as
listed below:
•
Use the 14-pin ribbon cable supplied with both cables to connect to the J5 header. DO NOT
use the flying leads that are also provided with some cables. Although the MultiPro
Desktop Tool and the Parallel Cable IV support multiple FPGA configuration modes, the
Spartan-3 Starter Kit board only supports the JTAG configuration method. The header is
designed for a keyed socket. However, the Spartan-3 Starter Kit uses only stake pins. The
outline of the keyed connector appears around the J5 header, as shown in
When properly inserted, the keyed header matches the outline on the board and the ribbon
cable crosses over the top edge of the board. The red-colored lead indicates pin 1 on the
cable and should be on the left side.
Figure 11-2: Digilent JTAG Cable Provided with Kit Connects to the J7 Header
Parallel Cable IV (PC IV)
http://www.xilinx.com/products/devkits/HW-PC4.htm
provides a detailed schematic of the J7 header and the JTAG programming
24
www.xilinx.com
in
Figure
21
J7
Chapter 11: JTAG Programming/Debugging Ports
1-2, supports the Xilinx download/debugging cable
23
UG130_c11_02_042704
Spartan-3 FPGA Starter Kit Board User Guide
22
20
UG130 (v1.2) June 20, 2008
Figure
11-3.