DEMOBOARD TLE 7230G Infineon Technologies, DEMOBOARD TLE 7230G Datasheet - Page 18

• Manufacturer Part Number: DEMOBOARD TLE 7230G
• Description: BOARD DEMO FOR TLE 7230G 1.0
• Manufacturer: Infineon Technologies

Specifications of DEMOBOARD TLE 7230G

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: DEMOBOARDTLE7230GIN

4.2
The device provides embedded protective functions. Integrated protection functions are
designed to prevent IC destruction under fault conditions described in this data sheet.
Fault conditions are considered as “outside” normal operating range. Protection
functions are not designed for continuous repetitive operation.
There is an over load and over temperature protection implemented in the SPIDER -
TLE7230G. The behavior of the protective functions can be set-up via SPI. Following
figure gives an overview about the protective functions.
Figure 7
4.2.1
The SPIDER - TLE7230G is protected in case of over load or short circuit of the load.
The behavior in case of over load can be configured as follows:
The over load flag (CLn) of the affected channel is cleared by a low-high transition of the
input signal. For timing information, please refer to
Data Sheet
a) The current is limited to
b) The current is limited to
IN
set. The channel may shut down due to over temperature.
off and the according over load flag Ln is set.
OUTn
Protection Functions
Over Load Protection
input mapping
Protective Functions
BOLn
MAPn
I
I
DS(LIM)
DS(LIM)
&
OVTn
. After time
. After time
OVLn
SPI Driver for Enhanced Relay Control
18
CLn
delay
t
&
t
d(off)
d(fault)
Tn
, the over loaded channel n switches
Figure 8
, the according over load flag Ln is
temperature
monitor
current
limitation
gate control
for details.
SPIDER - TLE7230G
Protection Functions
T
GND
V1.1, 2008-02-19
Protection .emf
OUTn