TOOLSTICK542PP Silicon Laboratories Inc, TOOLSTICK542PP Datasheet - Page 135

• Manufacturer Part Number: TOOLSTICK542PP
• Description: PLATFORM PROG TOOLSTICK F542
• Manufacturer: Silicon Laboratories Inc
• Series: ToolStickr
• Type: Microcontroller Programmerr

Specifications of TOOLSTICK542PP

• Contents: 2 Boards and USB Connecting Cable
• Processor To Be Evaluated: C8051F542
• Interface Type: USB
• Operating Supply Voltage: 2.7 V to 3.6 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: C8051F542
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1718

17. Oscillators and Clock Selection
C8051F54x devices include a programmable internal high-frequency oscillator, an external oscillator drive
circuit, and a clock multiplier. The internal oscillator can be enabled/disabled and calibrated using the
OSCICN, OSCICRS, and OSCIFIN registers, as shown in Figure 17.1. The system clock can be sourced
by the external oscillator circuit or the internal oscillator. The clock multiplier can produce three possible
base outputs which can be scaled by a programmable factor of 1, 2/3, 2/4 (or 1/2), 2/5, 2/6 (or 1/3), or 2/7:
Internal Oscillator x 2, External Oscillator x 2, or External Oscillator x 4.
17.1. System Clock Selection
The CLKSL[1:0] bits in register CLKSEL select which oscillator source is used as the system clock.
CLKSL[1:0] must be set to 01b for the system clock to run from the external oscillator; however the exter-
nal oscillator may still clock certain peripherals (timers, PCA) when the internal oscillator is selected as the
system clock. The system clock may be switched on-the-fly between the internal oscillator, external oscilla-
tor, and Clock Multiplier so long as the selected clock source is enabled and has settled.
The internal oscillator requires little start-up time and may be selected as the system clock immediately fol-
lowing the register write which enables the oscillator. The external RC and C modes also typically require
no startup time.
External crystals and ceramic resonators however, typically require a start-up time before they are settled
and ready for use. The Crystal Valid Flag (XTLVLD in register OSCXCN) is set to 1 by hardware when the
external crystal or ceramic resonator is settled. In crystal mode, to avoid reading a false XTLVLD, soft-
ware should delay at least 1 ms between enabling the external oscillator and checking XTLVLD.
VDD
Option 2
Option 3
XTAL2
XTAL2
Option 1
Option 4
XTAL2
10M
XTAL1
XTAL2
Figure 17.1. Oscillator Options
OSCICRS
Programmable Internal
Circuit
Rev. 1.1
Input
CAL
Clock Generator
OSCXCN
OSCIFIN
EXOSC/2
EXOSC
IOSC/2
OSC
IOSC
EN
EXOSC
OSCICN
CLOCK MULTIPLIER
IOSC
x4
CLKMUL
n
n
C8051F54x
CLKSEL
SYSCLK
135