FS-9017 Digi International, FS-9017 Datasheet - Page 17

• Manufacturer Part Number: FS-9017
• Description: JTAG-BOOSTER FOR PPC405XXX 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9017

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: IBM PPC405xxx, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

JTAG-Booster for IBM PPC405
Option /IROFFS= out of range
Please specify a smaller value
Part at specified position is not a IBM PPC405xxx
The option /CPUPOS= points to a part not a IBM PPC405xxx
Pins specified with /I2CCLK= and /I2CDAT= must have different
control cells
The pin specified with the option /I2CDAT= must be able to be switched to
high impedance while the pin specified with option /I2CCLK= is an active
output. See chapter 1.9 “Initialization file JT405xxx.INI”.
Pins specified with /I2CCLK= and /I2CDATI= must have different
control cells
The pin specified with the option /I2CDATI= must be able to be switched to
high impedance while the pin specified with option /I2CCLK= is an active
output. See chapter 1.9 “Initialization file JT405xxx.INI”.
Pins specified with /I2CDATO= and /I2CDATI= must have different
control cells
The pin specified with the option /I2CDATI= must be able to be switched to
high impedance while the pin specified with option /I2CDATO= is an active
output. See chapter 1.9 “Initialization file JT405xxx.INI”.
Specify only one of these options:
Some options are exclusive (i.e. /8BIT and /16BIT). Don't mix them.
Sum of instruction register bits to low. Should be at least 7 bits for a
IBM PPC405xxx
The sum of all instruction register bits in the JTAG chain does not fit to the
IBM PPC405xxx. Check the target connection. Check the target CPU type.
Check the settings for /IROFFS= and /CPUPOS= , if there are several
parts in the JTAG chain.
Target no longer connected
There is a cyclic check of the JTAG chain. Check target power. Check target
connection.
JTAG_PPC405a.doc
17