FS-9017 Digi International, FS-9017 Datasheet - Page 31

• Manufacturer Part Number: FS-9017
• Description: JTAG-BOOSTER FOR PPC405XXX 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9017

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: IBM PPC405xxx, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

The following options are valid for most functions:
/BIG
This option switches the byte ordering to big endian mode. This option must fit to
the target's endianess. Normally the target is configured to the right endianess
after reset. In some cases, the endianess can be changed within the
configuration file.
Default:
/DRIVER=x
A driver for the interface to the JTAG-BOOSTER on the parallel port may be
specified. /DRIVER=1 selects the fastest available driver, /DRIVER=4 selects
the slowest one. Use a slower driver if there are problems with JTAG-
BOOSTER.
Default:
/INI=file
An initialization file may be specified. By default the current directory is searched
for the file JT405xxx.INI. If this file is not found and no initialization file is
specified in the command line, default initialization values are used (see also
chapter 1.9 “Initialization file JT405xxx.INI”).
Note: The initialization file is not loaded for the functions /SAMPLE (chapter
2.11) and /SNAP (chapter 2.12).
Default:
JTAG_PPC405a.doc
Supported Options:
/CS0
/BIG
/BM
/ERASEALL /LATTICE
/LPT-BASE= /16BIT
L=
/DELAY=
/CPUPOS=
/I2CDATI=
/INI=
with x = 1,2,3,4
Little Endian
/DRIVER=3
/INI=JT405xxx.INI
/CS1
/NOCS
/PAUSE
/FILE-OFFSET=
/DEVICE-BASE= /DB=
/DEVICE=
/I2CDATO=
/REP
/CS2
/NOWRSETUP /TOP
/P
/LPT1
/8BIT
/FO=
/PIN=
I2CBIG
/CS3
/NODUMP
/LPT2
/NOMAN
/OFFSET=
/DRIVER=
/I2CCLK=
/WATCH=
/CS4
/NOERASE
/BYTE-MODE
/LPT3
/LENGTH=
/O=
/IROFFS=
/I2CDAT=
/OUT=
31