FS-9017 Digi International, FS-9017 Datasheet - Page 32

• Manufacturer Part Number: FS-9017
• Description: JTAG-BOOSTER FOR PPC405XXX 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9017

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: IBM PPC405xxx, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

/LATTICE
Besides the standard JTAG-Booster interface there may be several simple
"Parallel-Port-JTAG" interfaces supported. With this interfaces the programming
performance, of course, is reduced.
/LPT1 /LPT2 /LPT3
A printer port may be specified where the JTAG-Booster resides. If you are
using this program with WinNT, Win2000 or WinXP you must specify /LPT2 or
/LPT-BASE=378 to get access to the standard printer port.
Default:
/LPT-BASE
The physical I/O-Address of printer port may be specified instead of the logical
printer name. Useful option, if you work with WinNT or Win2000, because the
standard printer port is mapped as LPT2 here. Use the option /LPT-BASE=378
to get a command line which works independent of the operation system.
/OUT=file_or_device
All screen outputs are redirected to the specified file or device. Note that you
can't redirect to the same parallel port where the JTAG-Booster resides.
Default:
/PAUSE
With the option /PAUSE you can force the program to stop after each screen.
Please do not use this option if you redirect the output to a file.
Abbreviation:
/WATCH=
With the option /WATCH= a pin can be specified, which is toggled twice per
second, while the program is active. This pin may be the trigger of a watchdog.
This pin must be specified as output in the initialization file.
/IROFFS=
Specifies the position of the IBM PPC405xxx instruction register within the JTAG
chain. In most cases this option is not needed.
Default:
32
/LPT1
/OUT=CON
/P
/IROFFS=0
JTAG_PPC405a.doc