FS-9017 Digi International, FS-9017 Datasheet - Page 18

• Manufacturer Part Number: FS-9017
• Description: JTAG-BOOSTER FOR PPC405XXX 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9017

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: IBM PPC405xxx, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

JTAG-Booster for IBM PPC405
There are unknown parts in the JTAG chain. Please use the option
/IROFFS= to specify the instr. reg. offset of the CPU.
If there are unknown parts in the JTAG chain, the program isn’t able to
determine the logical position of the CPU’s instruction register.
There is no IBM PPC405xxx in the JTAG chain
No IBM PPC405xxx was found in the JTAG chain. Check the target power.
Try with option /DRIVER=4 again.
Value of option /FILE-OFFSET out of range
The value of the option /FILE-OFFSET= points behind end of file.
wrong driver #
The value specified with the option /DRIVER= is out of range.
Wrong Flash Identifier (xxxx)
No valid identifier found. Check the specified chip select signal and the bus
width. Try with the option /DEVICE= . Use the option /8BIT or /16BIT or
/32BIT to specify the correct data bus size.
Wrong length of boundary scan register. Should be 300 for a IBM
PPC405EP. (Should be 360 for a IBM PPC405GPr.)
The length of the boundary scan register of the selected part (if there are
more than one in the chain) does not fit to the IBM PPC405xxx. Check the
target connection. Check the target CPU type. Check the settings for
/IROFFS= and /CPUPOS= , if there are several parts in the JTAG chain.
18
JTAG_PPC405a.doc