85RF Fluke Electronics, 85RF Datasheet - Page 65
85RF
Manufacturer Part Number
85RF
Description
PROBE HIGH FREQ 500MHZ
Manufacturer
Fluke Electronics
Type
High Frequencyr
Specifications of 85RF
Impedance
10M Ohm
Voltage - Max
30VRMS, 200VDC
Lead Free Status / RoHS Status
Lead free by exemption / RoHS compliant by exemption
Ratings
-
Current Rating
-
Color
-
Termination
-
Wire Insulation Material
-
Cable Length
-
Other names
532457
4-1. Introduction
This chapter of the manual contains information regarding the maintenance
of your instrument. It includes information abut disassembly, performance
tests, calibration adjustments, and troubleshooting. The combined
performance tests are recommended as an acceptance test when the
instrument is first received, and can be used later as a preventive
maintenance tool.
A one-year calibration cycle is recommended to maintain the specifications
given in Chapter 1 of this manual. The test equipment required for the
performance tests or calibration adjustments is listed in Table 4-1. Test
equipment with equivalent specifications may also be used.
4-2. Service Information
The 8062A is warranted for a period of one year upon shipment of the
instrument to the original purchaser. Conditions of the warranty are given at
the front of this manual. Malfunctions that occur within the limits of the
warranty will be corrected at no cost to the purchaser. For in-warranty repair,
call (toll-free) 800 426-0361 for the address of the nearest Fluke Technical
Service Center designated to service your instrument (in Alaska, Hawaii,
Washington, or Canada call 206-356-5400). Ship the instrument postpaid in
the original shipping container (if available). Dated proof-of-purchase may
be required for in-warranty repairs.
Fluke Technical Service Centers are also available for calibration and/or
repair of instruments that are beyond the warranty period. Call (toll-free) 800
426-0361 for shipping information. Ship the instrument and remittance in
accordance with instructions received.
These servicing instructions are for use by qualified
personnel only. To avoid electric shock, do not perform
any servicing other than that contained in the operating
instructions unless you are qualified to do so.
Warning
Maintenance
Introduction
4
4-3