HD64F3437TFI16V Renesas Electronics America, HD64F3437TFI16V Datasheet - Page 579

no-image

HD64F3437TFI16V

Manufacturer Part Number
HD64F3437TFI16V
Description
MCU FLASH 60K 100-TQFP
Manufacturer
Renesas Electronics America
Datasheet

Specifications of HD64F3437TFI16V

Lead Free Status / RoHS Status
Lead free / RoHS Compliant

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
HD64F3437TFI16V
Manufacturer:
Renesas Electronics America
Quantity:
135
Part Number:
HD64F3437TFI16V
Manufacturer:
Renesas Electronics America
Quantity:
10 000
22.3
22.3.1
To enter software standby mode, set the standby bit (SSBY) in the system control register
(SYSCR) to 1, then execute the SLEEP instruction.
In software standby mode, the system clock stops and chip functions halt, including both CPU
functions and the functions of the on-chip supporting modules. Power consumption is reduced to
an extremely low level. The on-chip supporting modules and their registers are reset to their initial
states, but as long as a minimum necessary voltage supply is maintained, the contents of the CPU
registers and on-chip RAM remain unchanged.
22.3.2
The chip can be brought out of software standby mode by an RES input, STBY input, or external
interrupt input at the NMI pin, IRQ
Exit by Interrupt: When an NMI, IRQ
clock oscillator begins operating. After the waiting time set in bits STS2 to STS0 of SYSCR, a
stable clock is supplied to the entire chip, software standby mode is released, and interrupt
exception-handling begins. IRQ
transition to software standby (clear IRQ3E, IRQ4E, IRQ5E, and IRQ7E to 0).
Exit by RES Pin: When the RES input goes low, the clock oscillator begins operating. When
RES is brought to the high level (after allowing time for the clock oscillator to settle), the CPU
starts reset exception handling. Be sure to hold RES low long enough for clock oscillation to
stabilize.
Exit by STBY Pin: When the STBY input goes low, the chip exits from software standby mode
to hardware standby mode.
Software Standby Mode
Transition to Software Standby Mode
Exit from Software Standby Mode
3
, IRQ
0
to IRQ
4
, IRQ
0
, IRQ
2
5
, and IRQ
pins, or IRQ
1
, IRQ
2
, or IRQ
7
interrupts should be disabled before the
6
pin (including KEYIN
6
interrupt request signal is input, the
0
to KEYIN
15
547
).

Related parts for HD64F3437TFI16V