M38504E6FP#U0 Renesas Electronics America, M38504E6FP#U0 Datasheet - Page 81

• Manufacturer Part Number: M38504E6FP#U0
• Description: MCU 4.0/5.5V 24K PB-FREE 42-SSOP
• Manufacturer: Renesas Electronics America
• Series: 740/38000r

Specifications of M38504E6FP#U0

• Core Processor: 740
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SIO, UART/USART
• Peripherals: PWM, WDT
• Number Of I /o: 32
• Program Memory Size: 24KB (24K x 8)
• Program Memory Type: OTP
• Ram Size: 640 x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 5x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 42-SSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

3850 Group (Spec.H/A)
Electric Characteristic Differences Among
Mask ROM, Flash Memory, and One Time
PROM Version MCUs
There are differences in electric characteristics, operation margin,
noise immunity, and noise radiation among mask ROM, flash
memory, and One Time PROM version MCUs due to the differ-
ences in the manufacturing processes.
When manufacturing an application system with the flash memory,
One Time PROM version and then switching to use of the mask
ROM version, perform sufficient evaluations for the commercial
samples of the mask ROM version.
DATA REQUIRED FOR MASK ORDERS
The following are necessary when ordering a mask ROM produc-
tion:
1. Mask ROM Order Confirmation Form
2. Mark Specification Form
3. Data to be written to ROM, in EPROM form (three identical cop-
DATA REQUIRED FOR One Time PROM
PROGRAMMING ORDERS
The following are necessary when ordering a PROM programming
service:
1. ROM Programming Confirmation Form
2. Mark Specification Form (only special mark with customer’s
3. Data to be programmed to PROM, in EPROM form (three iden-
Rev.3.01
For the mask ROM confirmation and the mark specifications, re-
fer to the “Renesas Technology” Homepage Rom ordering
(http://www.renesas.com/eng/rom).
ies) or one floppy disk.
trade mark logo)
tical copies) or one floppy disk.
2003.06.20
page 79 of 98
ROM PROGRAMMING METHOD
The built-in PROM of the blank One Time PROM version and buit-
in EPROM version can be read or programmed with a
general-purpose PROM programmer using a special programming
adapter. Set the address of PROM programmer in the user ROM
area.
Table 20 Programming adapter
The PROM of the blank One Time PROM version is not tested or
screened in the assembly process and following processes. To en-
sure proper operation after programming, the procedure shown in
Figure 77 is recommended to verify programming.
Fig. 77 Programming and testing of One Time PROM version
Caution :
42P4B, 42S1B
42P2R-A/E
Package
The screening temperature is far higher
than the storage temperature. Never
expose to 150 °C exceeding 100 hours.
Programming with PROM
(150 °C for 40 hours)
Screening (Caution)
P R O M p r o g r a m m e r
F u n c t i o n a l c h e c k i n
V e r i f i c a t i o n w i t h
programmer
Name of Programming Adapter
t a r g e t d e v i c e
PCA4738S-42A
PCA4738F-42A