DF2378RVFQ34V Renesas Electronics America, DF2378RVFQ34V Datasheet - Page 974

• Manufacturer Part Number: DF2378RVFQ34V
• Description: IC H8S MCU FLASH 512K 144LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2378RVFQ34V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 34MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 97
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 6x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• For Use With: YLCDRSK2378 - KIT DEV EVAL H8S/2378 LCDYR0K42378FC000BA - KIT EVAL FOR H8S/2378HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)EDK2378 - DEV EVAL KIT FOR H8S/2378
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 21 Flash Memory (0.18-μm F-ZTAT Version)
5. Determine whether erasure of the necessary blocks has completed.
6. After erasure completes, clear FKEY and specify software protection.
21.4.3
This LSI has user boot mode which is initiated with different mode pin settings than those in user
program mode or boot mode. User boot mode is a user-arbitrary boot mode, unlike boot mode that
uses the on-chip SCI.
Only the user MAT can be programmed/erased in user boot mode. Programming/erasing of the
user boot MAT is only enabled in boot mode or programmer mode.
(1)
For the mode pin settings to start up user boot mode, see table 21.5.
When the reset start is executed in user boot mode, the built-in check routine runs. The user MAT
and user boot MAT states are checked by this check routine.
While the check routine is running, NMI and all other interrupts cannot be accepted.
Next, processing starts from the execution start address of the reset vector in the user boot MAT.
At this point, H'AA is set to FMATS because the execution MAT is the user boot MAT.
(2)
For programming the user MAT in user boot mode, additional processing made by setting FMATS
are required: switching from user-boot-MAT selection state to user-MAT selection state, and
switching back to user-boot-MAT selection state after programming completes.
Figure 21.13 shows the procedure for programming the user MAT in user boot mode.
Rev.7.00 Mar. 18, 2009 page 906 of 1136
REJ09B0109-0700
If more than one block is to be erased, update the FEBS parameter and repeat steps 3 to 5.
Blocks that have already been erased can be erased again.
If this LSI is restarted by a power-on reset immediately after user MAT erasure has completed,
secure a reset period (period of RES = 0) that is at least as long as normal 100 μs.
User Boot Mode Initiation
User MAT Programming in User Boot Mode
User Boot Mode