GT3F-2AD24 IDEC, GT3F-2AD24 Datasheet - Page 34

• Manufacturer Part Number: GT3F-2AD24
• Description: Electromechanical General Purpose Timer
• Manufacturer: IDEC
• Type: Off Delayr

Specifications of GT3F-2AD24

• Leaded Process Compatible: No
• No. Of Pins: 8
• Peak Reflow Compatible (260 C): No
• Switch Function: DPDT
• Supply Voltage: 250VAC
• Time Range Min: 0.05s
• Supply Current: 5A
• Time Range Max: 600s
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

www.idec.com
Special expertise is required to use Electronic Timers.
• All Electronic Timer modules are manufactured under IDEC's rig-
• Install the Electronic Timer according to instructions described in
• Make sure that the operating conditions are as described in the
• In these directions, safety precautions are categorized in order of
Warning
Warning notices are used to emphasize that improper operation may
cause sever personal injury or death.
• Turn power off to the Electronic timer before starting installation,
• Failure to turn power off may cause electrical shocks or fire hazard.
• Emergency stop and interlocking circuits must be configured out-
orous quality control system, but users must add a backup or fail
safe provision to the control system when using the Electronic
Timer in applications where heavy damage or personal injury may
occur should the Electronic Timer fail.
this catalog.
specifications. If you are uncertain about the specifications, contact
IDEC in advance.
importance to Warning and Caution.
removal, Wiring, maintenance, and inspection on the Electronic
Timer.
side the Electronic timer. If such a circuit is configured inside the
Electronic Timer, failure of the Electronic timer may cause mal-
function of the control system, or an accident.
T2 Time Range
Selector
Operation Mode
Selector
T1 Time Range
Selector
Timers
USA: (800) 262-IDEC or [phone], Canada: (888) 317-IDEC
Instructions: Setting GT3W Timer
T2 Setting Knob
T1 Setting Knob
Safety Precautions
1. The switches should be securely turned
2. Since changing the setting during timer oper-
Caution
Caution notices are used where inattention might cause personal
injury or damage to equipment.
• The Electronic Timer is designed for installation in equipment. Do
• Install the Electronic Timer in environments described in the speci-
• Use an IEC60127-approved fuse and circuit breaker on the power
• Do not disassemble, repair, or modify the Electronic Timer.
• When disposing of the Electronic Timer, do so as industrial waste.
not install the Electronic Timer outside equipment.
fications. If the Electronic Timer is used in places where it will be
subjected to high-temperature, high-humidity, condensation, corro-
sive gases, excessive vibrations, or excessive shocks, then electrical
shocks, fire hazard, or malfunction could result.
and output line outside the Electronic Timer.
using a flat screwdriver 4mm wide (maxi-
mum). Note that incorrect setting may cause
malfunction. The switches, which do not turn
infinitely, should not be turned beyond their
limits.
ation my cause malfunction, turn power off
before changing.
GT3W Series
G-47
G