E22D EATON CUTLER HAMMER, E22D Datasheet - Page 50

• Manufacturer Part Number: E22D
• Description: Incandescent Light Source Unit
• Manufacturer: EATON CUTLER HAMMER

48
Product description
The E26 Stacklight unit is a modular system that
provides illuminated and audible status indication
in all directions. Easily assembled plug-in modular
units include constant, flashing and strobe light
units, as well as mono-tonal, bitonal, intermittent
alarm systems. Stacklights may be assembled in a
variety of configurations, which are identified in
the Maximum Configurations table below.
Numerous lamp, colour and mounting options
further enhance the Stacklight’s versatility.
Light modules
Available in a variety of colours for both
incandescent lamps and LED lamps. To maximise
illumination and light dispersion, incandescent
units include an opal white diffuser while LED
diffusers are clear. See page 49.
Xenon strobe
Sets are similar to standard lens/diffuser units,
except each set consists of two lens units. The
lower unit includes the electronics and is
permanently fused to the upper unit which contains
the Xenon lamp. Xenon units may be placed in any
position in a complete Stacklight unit. They will
flash 60 times per minute when used with a
standard or flashing base. See page 49.
Catalogue number selection
Complete Stacklight modules
Stacklights accept a maximum of 6
incandescent or LED light modules or 2 Xenon
flasher modules and can be mounted in any
position on the stack.
Alarm units are mounted in the top most position
only.
Stacklights
E26 Series - Product description
Light module
Standard Stacklight base
For use with incandescent or standard LED for
steady, non-flashing illumination or with flashing
LEDs for flashing illumination. Bases include
terminal block for wiring, stacklight cover and
gasket. See page 50.
Flashing Stacklight base
Allows configuration of each light in the stack for
either steady or 60 times per minute flashing
illumination. Flashing circuit for use with
incandescent lamps only. (Maximum allowable
number of light modules is 2 at 12V, 4 at 24V and
6 at 48V and above.) See page 50.
For flashing LEDs use standard base with flashing
LED light module.
Maximum configurations
Incandescent
or
LED modules
6
5
4
3
2
1
Flashing base
and top cover
Standard base
and top cover
www.eatonelectrical.com
Xenon
modules
–
–
1
1
2
2
Alarm
modules
–
1
–
1
–
1
modules
6
6
5
5
4
4
Max.
number of
Alarms
May be fitted to the top of a complete Stacklight
unit or directly to the Stacklight bases, if desired.
Available in three versions, each with adjustable
sound levels. See page 51.
Features
Benefits
Modular construction
Wide variety of lens colours
Variety of lamp types and voltages
Mono-tonal, bi-tonal and intermittent alarm
systems
Combination of visible and audible alarms
Modular components reduce inventory
requirements, increase flexibility
Steady and flashing modes allow one light to
signal multiple conditions
No-tools assembly permits easy lamp
replacement
Alarm
Stacklight
Extension
Mounting
Alarm
Level
Level
Level
base
tube
base
3
2
1
Complete Stacklight
module
August 2004
PGO4700001U