HW-V5-ML505-UNI-G Xilinx Inc, HW-V5-ML505-UNI-G Datasheet - Page 19

• Manufacturer Part Number: HW-V5-ML505-UNI-G
• Description: KIT, EVAL PLATFORM, VIRTEX-5 LXT, ML505
• Manufacturer: Xilinx Inc

Specifications of HW-V5-ML505-UNI-G

• Kit Contents: RoHS Compliant
• Svhc: No SVHC (15-Dec-2010)
• Development Tool Type: Hardware / Software - Evaluation Kit
• Silicon Manufacturer: Xilinx
• Core Architecture: Virtex
• Silicon Family Name: Virtex-5
• Features: Linear Flash,
• Rohs Compliant: Yes

ML505/ML506/ML507 Getting Started Tutorial
UG348 (v3.0.3) June 18, 2009
R
3.
4.
Restore your computer's network settings when finished.
♦
♦
♦
Make sure the connection is running at 10 or 100 Mb/s and the ML50x board’s link
lights are on (the lights are located in the upper left corner of the board). The link LEDs
labeled 10, 100, and 1000 indicate the link is established at that speed.
♦
On the remote computer host, open a Web browser connection to http://192.168.1.10,
and follow the instructions on the loaded Web page.
♦
♦
Select Use the following IP address: (see
Enter this information: IP address = 192.168.1.10 and Subnet mask = 255.255.255.0
Click OK → OK to accept settings
You might need to force your computer to link in 10 Mb/s, 100 Mb/s, or
1000 Mb/s (duplex) mode. If so, then:
Right-click Local Area Connection → Properties → Configure → Advanced tab
→ Speed
You might need to turn off your browser's proxy (use direct Internet connection
mode) especially if you have multiple networking devices on your computer.
On the remote computer host, you can ping 192.168.1.10 to confirm that the
network connection is alive.
www.xilinx.com
Figure 10: IP Settings
ML50x Demonstrations in System ACE CF
Figure
10)
UG348_12_051408
19