CB-OBS433X-02-0 ConnectBlue, CB-OBS433X-02-0 Datasheet - Page 32

• Manufacturer Part Number: CB-OBS433X-02-0
• Description: SERIAL PORT ADAPTER U.FL
• Manufacturer: ConnectBlue

Specifications of CB-OBS433X-02-0

• Frequency: 2.402GHz ~ 2.48GHz
• Modulation Or Protocol: Bluetoothv2.1+EDR
• Applications: General Purpose
• Power - Output: 17dBm
• Sensitivity: -94dBm
• Voltage - Supply: 3.3 V ~ 6 V
• Current - Receiving: 200mA
• Current - Transmitting: 200mA
• Data Interface: Connector, 2 x 10 Header, 2 mm Pitch
• Antenna Connector: U.FL
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 809-1039

connectBlue
Copyright © 2010 connectBlue AB
A 5V system with open collector outputs is designed in Figure 14.
Figure 14: Open collector outputs
The serial interface of the module is UART logic level or RS232.
An external driver is needed if the module should be on other physical interfaces like RS422 (see section
CTS (Clear To Send) and RTS (Request To Send) are used for hardware flow control.
DSR (Data Set Ready) can be used to make a connect attempt. See the Serial Port Adapter AT commands specification.
DTR (Data Terminal Ready) can be used to detect if the module is up and running and ready to receive data.
The serial UART interface can be used in a host controller application with a UART interface. The design of the interface depends on the
power supply voltage of the host system; see the
10.2.2 Serial Interface
10.2.2.1 Logic level Mode
NOTE
The module must be configured to flow control none if hardware flow control is not used, see the Serial Port Adapter AT
Commands specification.
.
Logic Levels
section for voltage translation.
External RS422 driver
Page 32 of 42
).