AM29F160DT-90EI Spansion Inc., AM29F160DT-90EI Datasheet - Page 15

• Manufacturer Part Number: AM29F160DT-90EI
• Description: IC,EEPROM,NOR FLASH,1MX16/2MX8,CMOS,TSSOP,48PIN,PLASTIC
• Manufacturer: Spansion Inc.

Specifications of AM29F160DT-90EI

• Rohs Compliant: NO
• Cell Type: NOR
• Density: 16Mb
• Access Time (max): 90ns
• Interface Type: Parallel
• Boot Type: Top
• Address Bus: 21/20Bit
• Operating Supply Voltage (typ): 5V
• Operating Temp Range: -40C to 85C
• Package Type: TSOP
• Program/erase Volt (typ): 4.5 to 5.5V
• Sync/async: Asynchronous
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 4.5V
• Operating Supply Voltage (max): 5.5V
• Word Size: 8/16Bit
• Number Of Words: 2M/1M
• Supply Current: 50mA
• Mounting: Surface Mount
• Pin Count: 48
• Lead Free Status / Rohs Status: Not Compliant

Write Protect (WP#)
The Write Protect function provides a hardware
method of protecting the 16 Kbyte boot sector from
erasure without using V
If the system asserts V
disables erase functions for the 16 Kbyte boot sector
(SA34 for top boot device and SA0 for bottom boot de-
vice) independently of whether those sectors were
protected or unprotected using the method described
in
If the system asserts V
reverts to whether the 16 Kbyte boot sector was previ-
ously set to be protected or unprotected using the
method described in
on page
Temporary Sector Unprotect
This feature allows temporary unprotection of previ-
ously protected sectors to change data in-system. The
Sector Unprotect mode is activated by setting the RE-
SET# pin to V
sectors can be programmed or erased by selecting the
sector addresses. However, note that the boot sector is
still protected from erasure only if WP# is asserted low.
Once V
viously protected sectors are protected again.
on page 14
page 38
April 23, 2010 Am29F160D_00_D10
Sector Protection/Unprotection‚ on page
ID
12.
shows the timing diagrams, for this feature.
is removed from the RESET# pin, all the pre-
shows the algorithm, and
ID
. During this mode, formerly protected
Sector Protection/Unprotection‚
ID
IH
IL
.
on the WP# pin, the device
on the WP# pin, the device
Figure 19, on
12.
Figure 2,
D A T A S H E E T
Am29F160D
Notes:
1. All protected sectors unprotected. However, boot sector
2. All previously protected sectors are protected once
Figure 1. Temporary Sector Unprotect Operation
remains protected from erasure only if WP# is low.
again.
Unprotect Completed
Program Operations
Temporary Sector
Perform Erase or
RESET# = V
RESET# = V
(Note 1)
(Note 2)
START
ID
IH
13