DS33R11 Maxim Integrated Products, DS33R11 Datasheet - Page 300

• Manufacturer Part Number: DS33R11
• Description: Network Controller & Processor ICs Ethernet Mapper with Integrated T1-E1-J1
• Manufacturer: Maxim Integrated Products

Specifications of DS33R11

• Product: Framer
• Number Of Transceivers: 1
• Supply Voltage (max): 1.89 V, 3.465 V
• Supply Voltage (min): 1.71 V, 3.135 V
• Supply Current (max): 100 mA
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Package / Case: BGA

12 FUNCTIONAL TIMING
12.1 Functional Serial I/O Timing
The Serial Interface provides flexible timing to interconnect with a wide variety of serial interfaces. TDEN is an
input signal that can be used to enable or block the TSERO data. The “shaded bits” are not clocked by the
DS33R11. The TDEN must occur one bit before the effected bit in the TSERO stream. Note that polarity of the
TDEN is selectable through LI.TSLCR. In the figure below, TDEN is active low, allowing the bits to clock and
inactive high, causing the next data bit not be clocked. TCLKE can be gapped as shown in the following figure.
Similarly, the receiver function is governed by RCLKI, RDEN and RSERI. RSERI data will not be provided to the
receiver for the bits blocked when RDEN is inactive. The RDEN polarity can be programmed by LI.RSLCR. The
RDEN signal must be coincident with the RSERI bit that needs to be blocked.
Figure 12-1. Tx Serial Interface Functional Timing
Figure 12-2. Rx Serial Interface Functional Timing
RCLKI Gapped
TCLKE Gapped
TSERO
RSERI
TSER
gapped
TSER
TSERO
RSERI
TCLKE
RCLKI
RDEN
TCLK
TDEN
300 of 344