PIC18F26K80-E/MM Microchip Technology, PIC18F26K80-E/MM Datasheet - Page 291

• Manufacturer Part Number: PIC18F26K80-E/MM
• Description: ECAN, 64KB Flash, 4KB RAM, 16 MIPS, 12-bit ADC, CTMU 28 QFN-S 6x6mm TUBE
• Manufacturer: Microchip Technology
• Series: PIC® XLP™ 18Fr

Specifications of PIC18F26K80-E/MM

• Core Processor: PIC
• Core Size: 8-Bit
• Speed: 64MHz
• Connectivity: ECAN, I²C, LIN, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, LVD, POR, PWM, WDT
• Number Of I /o: 24
• Program Memory Size: 64KB (32K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 1K x 8
• Ram Size: 3.6K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 8x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: *
• Processor Series: PIC18F26K80
• Core: PIC
• Data Bus Width: 8 bit
• Data Ram Size: 3648 B
• Interface Type: I2C, SPI
• Maximum Clock Frequency: 64 MHz
• Number Of Programmable I/os: 24
• Number Of Timers: 5
• Operating Supply Voltage: 1.8 V to 5.5 V
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

20.4.8
In Sleep mode, all clock sources are disabled. Timer2/4
will not increment and the state of the module will not
change. If the ECCP1 pin is driving a value, it will con-
tinue to drive that value. When the device wakes up, it
will continue from this state. If Two-Speed Start-ups are
enabled, the initial start-up frequency from HF-INTOSC
and the postscaler may not be stable immediately.
In PRI_IDLE mode, the primary clock will continue to
clock the ECCP1 module without change.
 2011 Microchip Technology Inc.
OPERATION IN POWER-MANAGED
MODES
Preliminary
PIC18F66K80 FAMILY
20.4.8.1
If the Fail-Safe Clock Monitor (FSCM) is enabled, a clock
failure will force the device into the power-managed
RC_RUN mode and the OSCFIF bit of the PIR2 register
will be set. The ECCP1 will then be clocked from the
internal oscillator clock source, which may have a
different clock frequency than the primary clock.
20.4.9
Both Power-on Reset and subsequent Resets will force
all ports to Input mode and the ECCP registers to their
Reset states.
This forces the ECCP module to reset to a state
compatible with previous, non-enhanced CCP modules
used on other PIC18 and PIC16 devices.
EFFECTS OF A RESET
Operation with Fail-Safe
Clock Monitor (FSCM)
DS39977C-page 291