LAN9115-MT SMSC, LAN9115-MT Datasheet - Page 29

• Manufacturer Part Number: LAN9115-MT
• Description: IC ETHERNET CTRLR 10/100 100TQFP
• Manufacturer: SMSC
• Type: Single Chip MAC and PHYr

Specifications of LAN9115-MT

• Controller Type: Ethernet Controller
• Interface: Serial EEPROM
• Voltage - Supply: 3.3V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 100-TQFP, 100-VQFP
• Product: Ethernet Controllers
• Number Of Transceivers: 1
• Standard Supported: IEEE 802.3 or IEEE 802.3u
• Data Rate: 10 Mbps or 100 Mbps
• Supply Voltage (max): 3.3 V
• Supply Voltage (min): 1.8 V
• Maximum Operating Temperature: + 70 C
• Ethernet Connection Type: 100BASE-TX or 10BASE-T
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Supply: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 638-1010

Highly Efficient Single-Chip 10/100 Non-PCI Ethernet Controller
Datasheet
SMSC LAN9115
Reserved
FIELD
FIELD
30:0
2:1
31
3
0
Filter 3 Offset
Note 3.3
The Filter i Byte Mask defines which incoming frame bytes Filter i will examine to determine whether
or not this is a wake-up frame.
The Filter i command register controls Filter i operation.
The Filter i Offset register defines the offset in the frame’s destination address field from which the
frames are examined by Filter i.
DESCRIPTION
Must be zero (0)
Byte Mask: If bit j of the byte mask is set, the CRC machine processes byte number pattern - (offset
+ j) of the incoming frame. Otherwise, byte pattern - (offset + j) is ignored.
DESCRIPTION
Address Type: Defines the destination address type of the pattern. When bit is set, the pattern
applies
only to multicast frames. When bit is cleared, the pattern applies only to unicast frames.
RESERVED
Enable Filter: When bit is set, Filter i is enabled, otherwise, Filter i is disabled.
Command
Filter 3
Filter 1 CRC-16
Filter 3 CRC-16
When wake-up frame detection is enabled via the WUEN bit of the
Control and Status
the state of the Disable Broadcast Frames (BCAST) bit in the
Register.
Table 3.2 Wake-Up Frame Filter Register Structure
Reserved
Table 3.3 Filter i Byte Mask Bit Definitions
Table 3.4 Filter i Command Bit Definitions
Filter 2 Offset
FILTER I BYTE MASK DESCRIPTION
Command
Register, a broadcast wake-up frame will wake-up the device despite
Table
FILTER i COMMANDS
Table 3.5
Filter 2
Filter 0 Byte Mask
Filter 1 Byte Mask
Filter 2 Byte Mask
Filter 3 Byte Mask
DATASHEET
3.3, describes the byte mask’s bit fields.
29
describes the Filter i Offset bit fields.
Reserved
Filter 1Offset
Table 3.4
Command
Filter 1
Filter 0 CRC-16
Filter 2 CRC-16
shows the Filter I command register.
Reserved
MAC_CR—MAC Control
Filter 0 Offset
Revision 1.5 (07-11-08)
WUCSR—Wake-up
Command
Filter 0