TDA8034T/C1,118 NXP Semiconductors, TDA8034T/C1,118 Datasheet - Page 10

• Manufacturer Part Number: TDA8034T/C1,118
• Description: IC SMART CARD INTERFACE 16SOIC
• Manufacturer: NXP Semiconductors
• Type: Smart Card Interfacer

Specifications of TDA8034T/C1,118

• Package / Case: 16-SOIC (3.9mm Width)
• Controller Type: Smart Card Interface
• Interface: Analog
• Voltage - Supply: 3V, 5V
• Current - Supply: 65mA
• Operating Temperature: -25°C ~ 85°C
• Mounting Type: Surface Mount
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 25 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 935288349118

NXP Semiconductors
TDA8034T_TDA8034AT
Product data sheet
8.8 V
8.9 Fault detection
Remark: The value of period T is 64 times the period interval of the internal oscillator (i.e.
± 25 μs).
The V
The V
120 mA. This detection is internally filtered, enabling spurious current pulses up to
200 mA with a duration of a few milliseconds to be drawn by the card without causing
deactivation. However, the average current value must stay below maximum; see
The following conditions are monitored by the fault detection circuit:
Fault detection monitors two different situations:
Fig 7.
•
•
•
•
•
•
•
CC
CMDVCC
Short-circuit or high current on pin V
Card removal during transaction
V
V
V
Overheating
Outside card sessions, pin CMDVCCN is HIGH: pin OFFN is LOW if the card is not in
the reader and HIGH if the card is in the reader. Any voltage drop on V
by the voltage supervisor. This generates an internal power-on reset pulse but does
not act upon the pin OFFN signal. The card is not powered-up and short-circuits or
overheating are not detected.
OSCINT
regulator
DDP
DD
DD(INTF)
CC
CC
XTAL1
RST
CLK
V
falling
I/O
CC
buffer has an internal overload protection with a threshold value of approximately
buffer is able to continuously deliver up to 65 mA at V
OSCINT = internal oscillator.
Deactivation sequence
falling
falling
All information provided in this document is subject to legal disclaimers.
t10 t11
Rev. 3.0. — 17 January 2011
high frequency
t12
t
deact
t13
TDA8034T; TDA8034AT
CC
t14
low frequency
CC
= 5 V or 3 V.
Smart card interface
© NXP B.V. 2011. All rights reserved.
DD
is detected
001aak995
Table
10 of 29
8.