MCIMX537CVV8C Freescale Semiconductor, MCIMX537CVV8C Datasheet - Page 26

• Manufacturer Part Number: MCIMX537CVV8C
• Description: IC, 32-BIT MPU, 800 MHz, 529-BGA
• Manufacturer: Freescale Semiconductor
• Series: ARM Cortex-A8r

Specifications of MCIMX537CVV8C

• Core Size: 32bit
• Program Memory Size: 288KB
• Cpu Speed: 1GHz
• Digital Ic Case Style: BGA
• No. Of Pins: 529
• Operating Temperature Range: -20°C To +85°C
• Msl: MSL 3 - 168 Hours
• Lead Free Status / Rohs Status: Supplier Unconfirmed

Electrical Characteristics
26
•IO Supplies (NVCC_xxx) below or equal to 2.8 V nom./3.1 V max. should not precede
•IO Supplies (NVCC_xxx) above 2.8 V nom./3.1 V max. should be powered ON only after
•In case VDD_DIG_PLL and VDD_ANA_PLL are powered ON from internal voltage regulator
•VDD_REG supply is required to be powered ON to enable DDR operation. It must be powered
•NVCC_EIM_DRAM_2P5 PoP additional power line timing is the same as DVV_REG
•VDDA and VDDAL1 can be powered ON anytime before POR_B, regardless of any other power
•VDDGP can be powered ON anytime before POR_B, regardless of any other power signal.
•VP and VPH can be powered up together, or anytime after, the VCC. VP and VPH should come
•TVDAC_DHVDD and TVDAC_AHVDDRGB should be powered from the same regulator. This
NVCC_CKIH. They can start powering ON during NVCC_CKIH ramp-up, before it is
stabilized. Within this group, the supplies can be powered-up in any order.
NVCC_CKIH is stable.
(default case for i.MX53xD), there are no related restrictions on VDD_REG, as it is used as their
internal regulators power source.
If VDD_DIG_PLL and VDD_ANA_PLL are powered on externally, to reduce current leakage
during the power-up, it is recommended to activate the VDD_REG before or at the same time
with VDD_DIG_PLL and VDD_ANA_PLL. If this sequencing is not possible, make sure that
the 2.5 V VDD_REG supply shut-off output impedance is higher than 1 kΩ when it is inactive.
on after VCC and before NVCC_EMI_DRAM. The sequence should be:
signal.
before POR.
is due to ESD diode protection circuit, that may cause current leakage if one of the supplies is
powered ON before the other.
The POR_B input must be immediately asserted at power-up and remain
asserted until after the last power rail reaches its working voltage.
i.MX53xD Applications Processors for Consumer Products, Rev. 3
VCC →VDD_REG →NVCC_EMI_DRAM
NOTE
Freescale Semiconductor