ISP1301BS ST-Ericsson Inc, ISP1301BS Datasheet - Page 12

no-image

ISP1301BS

Manufacturer Part Number
ISP1301BS
Description
IC USB OTG TRANSCEIVER 24-HVQFN
Manufacturer
ST-Ericsson Inc
Type
Transceiverr
Datasheet

Specifications of ISP1301BS

Number Of Drivers/receivers
1/1
Protocol
USB 2.0
Voltage - Supply
2.7 V ~ 4.5 V
Mounting Type
Surface Mount
Package / Case
24-VQFN Exposed Pad, 24-HVQFN, 24-SQFN, 24-DHVQFN
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
568-1166
ISP1301BS,157

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ISP1301BS
Manufacturer:
ST
0
Part Number:
ISP1301BS
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Company:
Part Number:
ISP1301BS
Quantity:
1 044
Part Number:
ISP1301BS,118
Manufacturer:
PHILIPS/飞利浦
Quantity:
20 000
Part Number:
ISP1301BSFA
Manufacturer:
SILICON
Quantity:
2 300
Part Number:
ISP1301BSTS
Manufacturer:
ST
Quantity:
20 000
Philips Semiconductors
ISP1301_3
Product data sheet
7.10.10 V
7.10.11 C1 and C2
7.10.7 DP and DM
7.10.8 ID
7.10.9 V
Table 12
operation.
The VP and VM pins are single-ended receiver outputs of the DP and DM pins,
respectively.
The DP (data plus) and DM (data minus) pins implement the USB data signals. When in
transparent general-purpose buffer mode, the ISP1301 operates as a level shifter
between the (DAT/VP, SE0/VM) and (DP, DM) pins.
The ID (identification) pin is connected to the ID pin on the USB mini receptacle. An
internal pull-up resistor (to VREG3V3) is connected to this pin. When bit ID_PULLDOWN
is set, the ID pin will be shorted to ground.
This pin acts as an input to the V
When the VBUS_DRV bit of the OTG Control register is asserted, the ISP1301 tries to
drive V
8 mA.
This pin is an input and supplies power to the ISP1301. The ISP1301 operates when V
is between 2.7 V and 4.5 V.
The C1 and C2 pins are to connect the flying capacitor of the charge pump. The output
current capacity of the charge pump depends on the value of the capacitor. For maximum
efficiency, place capacitors as close as possible to the pins.
Fig 6. Charge pump capacitor
BUS
CC
Bit TRANSP_EN = 0
Bit UART_EN = 0
Pin OE_N/INT_N = HIGH
BUS
shows the operation of the SE0/VM, DAT/VP and RCV pins during the receive
to a voltage of 4.4 V to 5.25 V, with an output current capability of at least
Rev. 03 — 21 February 2006
ISP1301BS
BUS
V
CC
comparator or an output from the charge pump.
C1
C2
V
BUS
C ext
004aaa278
I L
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
USB OTG transceiver
ISP1301
11 of 51
CC

Related parts for ISP1301BS