PEB 3086 F V1.4 Infineon Technologies, PEB 3086 F V1.4 Datasheet - Page 200

• Manufacturer Part Number: PEB 3086 F V1.4
• Description: IC ISDN ACCESS CTRLR TQFP64
• Manufacturer: Infineon Technologies
• Series: ISAC™r

Specifications of PEB 3086 F V1.4

• Function: Subscriber Access Controller
• Interface: HDLC, IOM-2, ISDN, Parallel, SCI
• Number Of Circuits: 1
• Voltage - Supply: 3.3V
• Current - Supply: 30mA
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 64-LFQFP
• Includes: D-Channel Access Control and Priority Handler, Monitor Channel Handler, Non-Auto Mode, Transparent Mode
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power (watts): -
• Other names: PEB3086FV1.4XT; PEB3086FV14NP; PEB3086FV14XP; SP000007571; SP000007572

EN_CI1 ... Enable CI1 Handler Data
0: CI1 handler data access is disabled
1: CI1 handler data access is enabled
Note: The timeslot for the C/I1 handler cannot be programmed but is fixed to IOM
D_EN_D ... Enable D-timeslot for D-channel controller
D_EN_B2 ... Enable B2-timeslot for D-channel controller
D_EN_B1 ... Enable B1-timeslot for D-channel controller
These bits are used to select the timeslot length for the D-channel HDLC controller
access as it is capable to access not only the D-channel timeslot. The host can
individually enable two 8-bit timeslots B1- and B2-channel (D_EN_B1, D_EN_B2) and
one 2-bit timeslot D-channel (D_EN_D) on IOM-2. The position is selected via CS2-0.
0: D-channel controller does not access timeslot data B1, B2 or D, respectively
1: D-channel controller does access timeslot data B1, B2 or D, respectively
CS2-0 ... Channel Select for D-channel controller
This register is used to select one of eight IOM channels. If enabled, the D-channel data
is connected to the corresponding timeslots of that IOM channel.
Note: The reset value is determined by the channel select pins CH2-0 which are directly
4.4.6.1
Value after reset: 00
DCIC_CR
Write access to this register is possible if IOM_CR.CI_CS = 0 or IOM_CR.CI_CS = 1.
Read access to this register is possible only if IOM_CR.CI_CS = 1.
CS2-0 ... Channel Select for C/I0 Handler
This register is used to select one of eight IOM channels. If enabled, the data of the
C/I0 handler is connected to the corresponding C/I0 timeslot of that IOM channel. The
reset value is determined by the channel select pins CH2-0 which are mapped to CS2-0.
Data Sheet
channel 1.
mapped to CS2-0. It should be noted that writing DCI_CR.CS2-0 will also write to
DCIC_CR.CS2-0 and therefore modify the channel selection for the data of the
C/I0 handler.
DCIC_CR - Control Register for CI0 Handler (IOM_CR.CI_CS=1)
7
0
H
0
0
0
200
0
Detailed Register Description
CS2-0
0
RD/WR (13)
PEB 3086
2003-01-30
ISAC-SX