SAM3N2A Atmel Corporation, SAM3N2A Datasheet - Page 714

• Manufacturer Part Number: SAM3N2A
• Manufacturer: Atmel Corporation

Specifications of SAM3N2A

• Flash (kbytes): 128 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 48 MHz
• Cpu: Cortex-M3
• # Of Touch Channels: 23
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 47
• Ext Interrupts: 47
• Quadrature Decoder Channels: 2
• Usb Speed: No
• Usb Interface: No
• Spi: 2
• Twi (i2c): 2
• Uart: 3
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

35.4.9
35.4.9.1
35.4.9.2
714
SAM3N
Crystal Oscillators Design Consideration Information
Choosing a Crystal
Printed Circuit Board (PCB)
When choosing a crystal for the 32768 Hz Slow Clock Oscillator or for the 3-20 MHz Oscillator,
several parameters must be taken into account. Important parameters between crystal and
SAM3N specifications are as follows:
SAM3N Oscillators are low power oscillators requiring particular attention when designing PCB
systems.
• Load Capacitance
• Drive Level
• Equivalent Series Resistor (ESR)
• Shunt Capacitance
– C
– Crystal drive level >= Oscillator Drive Level. Having a crystal drive level number
– Crystal ESR <= Oscillator ESR Max. Having a crystal with ESR value higher than
– Max. crystal Shunt capacitance <= Oscillator Shunt Capacitance (
order to oscillate at the target frequency. The crystal must be chosen according to
the internal load capacitance (C
load capacitance will result in a frequency drift.
lower than the oscillator specification may damage the crystal.
the oscillator may cause the oscillator to not start.
crystal with ESR value higher than the oscillator may cause the oscillator to not start.
crystal
is the equivalent capacitor value the oscillator must “show” to the crystal in
L
) of the on-chip oscillator. Having a mismatch for the
C
SHUNT
11011A–ATARM–04-Oct-10
).
Having a