TDA8920B NXP Semiconductors, TDA8920B Datasheet - Page 8

• Manufacturer Part Number: TDA8920B
• Description: The TDA8920B is a high efficiency class-D audio power amplifier with very lowdissipation
• Manufacturer: NXP Semiconductors

Philips Semiconductors
TDA8920B_2
Product data sheet
8.3.1 OverTemperature Protection (OTP)
8.3.2 OverCurrent Protection (OCP)
8.2 Pulse width modulation frequency
8.3 Protections
The output signal of the amplifier is a PWM signal with a carrier frequency of
approximately 317 kHz. Using a 2nd-order LC demodulation filter in the application results
in an analog audio signal across the loudspeaker. This switching frequency is fixed by an
external resistor R
carrier frequency is between 300 kHz and 350 kHz.
Using an external resistor of 30 k on the OSC pin, the carrier frequency is set to
317 kHz.
If two or more class-D amplifiers are used in the same audio application, it is advisable to
have all devices operating at the same switching frequency by using an external clock
circuit.
The following protections are included in TDA8920B:
The reaction of the device to the different fault conditions differs per protection.
If the junction temperature T
The power stage will start switching again if the temperature drops to approximately
130 C, thus there is a hysteresis of approximately 20 C.
When the loudspeaker terminals are short-circuited or if one of the demodulated outputs
of the amplifier is short-circuited to one of the supply lines, this will be detected by the
OverCurrent Protection (OCP). If the output current exceeds the maximum output current
of 8 A, this current will be limited by the amplifier to 8 A while the amplifier outputs remain
switching (the amplifier is NOT shut-down completely).
The amplifier can distinguish between an impedance drop of the loudspeaker and a
low-ohmic short across the load. In the TDA8920B this impedance threshold (Z
depends on the supply voltage used.
When a short is made across the load causing the impedance to drop below the threshold
level (< Z
try to restart again. If the short circuit condition is still present after this time this cycle will
be repeated. The average dissipation will be low because of this low duty cycle.
•
•
•
•
OverTemperature Protection (OTP)
OverCurrent Protection (OCP)
Window Protection (WP)
Supply voltage protections:
– UnderVoltage Protection (UVP)
– OverVoltage Protection (OVP)
– UnBalance Protection (UBP)
th
) then the amplifier is switched off completely and after a time of 100 ms it will
OSC
Rev. 02 — 07 November 2005
connected between pin OSC and V
j
> 150 C, then the power stage will shut-down immediately.
2
100 W class-D power amplifier
SSA
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
. An optimal setting for the
TDA8920B
th
)
8 of 34