TDA8950 NXP Semiconductors, TDA8950 Datasheet - Page 36

no-image

TDA8950

Manufacturer Part Number
TDA8950
Description
The TDA8950 is a high-efficiency Class D audio power amplifier
Manufacturer
NXP Semiconductors
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
TDA8950
Manufacturer:
ST
0
Part Number:
TDA8950J
Manufacturer:
NXP
Quantity:
30 000
Part Number:
TDA8950J
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
TDA8950J/N1
Manufacturer:
NXP
Quantity:
9 000
Part Number:
TDA8950J/N1
0
Part Number:
TDA8950J/N1,112
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
TDA8950TH
Manufacturer:
SANYOU
Quantity:
44 500
Part Number:
TDA8950TH
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
TDA8950TH-N1B
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
TDA8950TH/N1
Manufacturer:
BCD
Quantity:
4 000
Part Number:
TDA8950TH/N1
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
TDA8950TH/N1,118
Manufacturer:
BCD
Quantity:
120 000
NXP Semiconductors
16. Soldering of through-hole mount packages
TDA8950_2
Product data sheet
16.1 Introduction to soldering through-hole mount packages
16.2 Soldering by dipping or by solder wave
16.3 Manual soldering
For further information on temperature profiles, refer to Application Note AN10365
“Surface mount reflow soldering description” .
This text gives a very brief insight into wave, dip and manual soldering.
Wave soldering is the preferred method for mounting of through-hole mount IC packages
on a printed-circuit board.
Driven by legislation and environmental forces the worldwide use of lead-free solder
pastes is increasing. Typical dwell time of the leads in the wave ranges from
3 seconds to 4 seconds at 250 C or 265 C, depending on solder material applied, SnPb
or Pb-free respectively.
The total contact time of successive solder waves must not exceed 5 seconds.
The device may be mounted up to the seating plane, but the temperature of the plastic
body must not exceed the specified maximum storage temperature (T
printed-circuit board has been pre-heated, forced cooling may be necessary immediately
after soldering to keep the temperature within the permissible limit.
Apply the soldering iron (24 V or less) to the lead(s) of the package, either below the
seating plane or not more than 2 mm above it. If the temperature of the soldering iron bit is
less than 300 C it may remain in contact for up to 10 seconds. If the bit temperature is
between 300 C and 400 C, contact may be up to 5 seconds.
Fig 30. Temperature profiles for large and small components
temperature
MSL: Moisture Sensitivity Level
Rev. 02 — 11 June 2009
= minimum soldering temperature
maximum peak temperature
minimum peak temperature
= MSL limit, damage level
2
150 W class-D power amplifier
temperature
peak
stg(max)
TDA8950
© NXP B.V. 2009. All rights reserved.
001aac844
). If the
time
36 of 39

Related parts for TDA8950