STR751FR1 STMicroelectronics, STR751FR1 Datasheet - Page 8

• Manufacturer Part Number: STR751FR1
• Description: 32-bit MCU
• Manufacturer: STMicroelectronics

Specifications of STR751FR1

• Smart Low Power Modes: SLOW, WFI, STOP and STANDBY with backup registers
• Conversion Time: min. 3.75 μs

Introduction
8/84
periodic interrupt. It is clocked by an external 32.768 kHz oscillator or the internal low power
RC oscillator. The RC has a typical frequency of 300 kHz and can be calibrated.
WDG (watchdog timer)
The watchdog timer is based on a 16-bit downcounter and 8-bit prescaler. It can be used as
watchdog to reset the device when a problem occurs, or as free running timer for application
time out management.
Timebase timer (TB)
The timebase timer is based on a 16-bit auto-reload counter and not connected to the I/O
pins. It can be used for software triggering, or to implement the scheduler of a real-time
operating system.
Synchronizable standard timers (TIM2:0)
The three standard timers are based on a 16-bit auto-reload counter and feature up to 2
input captures and 2 output compares (for external triggering or time base / time out
management). They can work together with the PWM timer via the Timer Link feature for
synchronization or event chaining. In reset state, timer Alternate Function I/Os are
connected to the same
I/O ports in both 64-pin and 100-pin devices. To optimize timer functions in 64-pin devices,
timer Alternate Function I/Os can be connected, or “remapped”, to other I/O ports as
summarized in
a control register.
Table 3. Standard timer alternate function I/Os
Any of the standard timers can be used to generate PWM outputs. One timer (TIM0) is
mapped to a DMA channel.
Motor control PWM timer (PWM)
The Motor Control PWM Timer (PWM) can be seen as a three-phase PWM multiplexed on 6
channels. The 16-bit PWM generator has full modulation capability (0...100%), edge or
centre-aligned patterns and supports dead-time insertion. It has many features in common
with the standard TIM timers which has the same architecture and it can work together with
the TIM timers via the Timer Link feature for synchronization or event chaining.The PWM
timer is mapped to a DMA channel.
TIM 0
TIM 1
TIM 2
Standard timer functions
Input Capture
Output Compare/PWM
Input Capture
Output Compare/PWM
Input Capture
Output Compare/PWM
Table 3
and detailed in
Table
STR750Fxx STR751Fxx STR752Fxx STR755Fxx
package
100-pin
6. This remapping is done by the application via
2
2
2
2
2
2
Number of alternate function I/Os
Default mapping
1
1
1
1
2
1
64-pin package
Remapped
2
1
2
2
1
2