TLE 7263E Infineon Technologies, TLE 7263E Datasheet - Page 16

• Manufacturer Part Number: TLE 7263E
• Manufacturer: Infineon Technologies

Specifications of TLE 7263E

• Packages: PG-DSO-36
• Transceiver: High Speed CAN ISO 11898 - 5 / 1 x LIN2.0 / J2602
• Voltage Regulator Output: 200 mA + 200 mA
• Watchdog: Window Watchdog
• Quiescent Current (max.): 49 ?A (typ) Sleep Mode (5V on)
• Standby Current: 68 ?A (typ) Stop Mode (5V on)

4.7
The SBC Stop Mode has the advantage of reducing the current consumption to a
minimum, while supplying the microcontroller with its quiescent current during its power
saving mode (“Stop”). This mode is entered via SPI command, and turns-off the
integrated bus transceivers and respective termination, but the main voltage regulator
remains active. In contrast to Cyclic Sense the HS-On state is entered once Cyclic Wake
is selected, immediately providing supply voltage at the OUTHS pin. The microcontroller
determines the duration of the HS-On state via the STS input pin (see
transitions from that HS-Off into the HS-On state are done by the selected cyclic wake
period or by a bus message. The microcontroller is notified by the WKO (Wake-Up
Output) that the HS-On state has been entered. Further notification is done in the same
way as for Cyclic Sense in Stop Mode.
Figure 9
Data Sheet
sampling of MON1…3 inputs
[MON4 active permanently]
SBC Stop Mode with Cyclic Wake
MONx inputs
Initialization of
switched into SBC Standby mode
State Diagram “SBC Stop Mode with Cyclic Wake”
1)
2)
MS2
automatically once current
if initialization fails, device is
window watchdog activated
0
threshold is exceeded
SBC Active Mode
1)
MS1
0 / 1
MS0
0 / 1
µController SPI-Command:
- select „cyclic wake“ via SPI Bit
- select „cyclic wake period“ via SPI Timing Bits
- select HS-Switch on-time via SPI „On-Time Bit“
- select SBC Stop Mode via SPI Mode Bits
- window watchdog activation / deactivation via SPI
[„off“ once current consumption below threshold]
Vcc1
automatic transition by:
- cyclic wake period
- CAN message
- LIN message
ON
MS2
MS2
1
1
SBC Stop Mode
HS Cyclic Wake
HS-Switch = OFF
HS-Switch = ON
MS1
MS1
1
1
after „on-time“
MS0
MS0
via STS pin
1
1
or
16
Vcc1
Vcc1
ON
ON
SBC Standby Mode
STS
WKO
µC wake-up inputs
cyclic wake-up
Vcc1
ON
cyclic_wake_stop_TLE7263
Rev. 1.70, 2009-09-30
operating mode
Figure
select SBC
µC
Power Up
Start Up
2)
TLE 7263E
9). Further
Features