TLE 7263E Infineon Technologies, TLE 7263E Datasheet - Page 20

• Manufacturer Part Number: TLE 7263E
• Manufacturer: Infineon Technologies

Specifications of TLE 7263E

• Packages: PG-DSO-36
• Transceiver: High Speed CAN ISO 11898 - 5 / 1 x LIN2.0 / J2602
• Voltage Regulator Output: 200 mA + 200 mA
• Watchdog: Window Watchdog
• Quiescent Current (max.): 49 ?A (typ) Sleep Mode (5V on)
• Standby Current: 68 ?A (typ) Stop Mode (5V on)

Figure 10
4.10
The TLE 7263E offers a transceiver, which is compatible to ISO 9141 and LIN
specification 2.0. For fail safe reasons the transceiver already has a pull-up resistor of
30 kΩ implemented. In order to achieve the required timing for the dominant to recessive
transition of the bus signal an additional external termination resistor of 1 kΩ is required,
when the LIN node is used as a master. This termination resistor will automatically be
turned off via the “Master Termination Switch” pin (MTS) once the LIN module enters LIN
Sleep Mode or when the SBC enters Sleep Mode. The transceiver is protected against
short to battery and short to GND.
For LIN automotive applications in the United States a dedicated mode by the name
“Low Slope Mode” can be used. This mode limits the maximum data transmission rate
to 10.4 kBaud by switching to a different slew rate. Operating with the default slew rate
at up to 20 kBaud may cause interferences with the AM radio band.
A bus wake-up via a LIN message (minimum dominant time
mode sets the RxD pin and the WKO pin to low. in addition the MTS is switched ON. The
LIN transceiver has to be enabled to reset the wake-up capability after a bus wake event
and after power-up.
In case of a “TxD dominant time out failure” or a “transmitter thermal shutdown” the SPI
bit 9 is set. After a SPI read-out this bit will be reset unless one of the failure conditions
is still present.
Note: In case of a short to GND on the LIN bus a RxD dominant signal is generated by
Data Sheet
the SBC. In the case that RxD is dominant the device can not go into low power
mode from normal mode.
TLE 7263 R
LIN Transceiver
Application of the SPLIT pin for normal nodes and one stub node
CANH
SPLIT
CANL
10nF
termination
60Ohm
60Ohm
split
termination
at stub
split
CANH
1,5 kOhm
TLE 7263 R
10nF
CAN
Bus
SPLIT
20
1,5 kOhm
CANL
termination
split
60Ohm
60Ohm
10nF
CANH
t
SPLIT
CANL
TLE 7263 R
>
t
wake
Rev. 1.70, 2009-09-30
) from low power
TLE 7263E
Features