PIC24H Microchip Technology, PIC24H Datasheet - Page 2

• Manufacturer Part Number: PIC24H
• Description: Flash Programming Specification
• Manufacturer: Microchip Technology

dsPIC33F/PIC24H PROGRAMMING SPECIFICATION
FIGURE 2-1:
This specification is divided into major sections that
describe the programming methods independently.
Section 3.0 “Device Programming – Enhanced
ICSP”
Section 5.0 “Device Programming – ICSP” describes
the ICSP method.
2.1
All devices in the dsPIC33F/PIC24H family are dual volt-
age supply designs: one supply for the core and another
for the peripherals and I/O pins. A regulator is provided
on-chip to alleviate the need for two external voltage
supplies.
All of the dsPIC33F/PIC24H devices power their core
digital logic at a nominal 2.5V. To simplify system
design, all devices in the dsPIC33F/PIC24H Program-
ming Specification family incorporate an on-chip regu-
lator that allows the device to run its core logic from
V
The regulator provides power to the core from the other
V
be connected to the V
helps to maintain the stability of the regulator. The
specifications for core voltage and capacitance are
listed in Section TABLE 8-1: “AC/DC Characteristics
and Timing Requirements”.
DS70152D-page 2
DD
DD
Programmer
.
pins. A low-ESR capacitor (such as tantalum) must
describes
Power Requirements
the
PROGRAMMING SYSTEM
OVERVIEW FOR
ENHANCED ICSP™
DDCORE
Enhanced
dsPIC33F/PIC24H
On-Chip Memory
pin (Figure 2-2). This
Programming
Executive
ICSP
method.
Preliminary
FIGURE 2-2:
2.2
The program Flash memory on the dsPIC33F/PIC24H
has a specific write/erase requirement that must be
adhered to for proper device operation. The rule is that
any given word in memory must not be written without
first erasing the page in which it is located. Thus, the
easiest way to conform to this rule is to write all the data
in a programming block within one write cycle. The pro-
gramming methods specified in this document comply
with this requirement.
Note:
Note 1:
Program Memory Write/Erase
Requirements
C
A program memory word can be pro-
grammed twice before an erase, but only
if (a) the same data is used in both pro-
gram operations or (b) bits containing ‘1’
are set to ‘0’ but no ‘0’ is set to ‘1’.
F
These are typical operating voltages. Refer
to Section TABLE 8-1: “AC/DC Charac-
teristics and Timing Requirements” for
the full operating ranges of V
3.3V
CONNECTIONS FOR THE
ON-CHIP REGULATOR
V
V
V
© 2007 Microchip Technology Inc.
DD
DDCORE
SS
dsPIC33F/PIC24H
www.DataSheet4U.com
DD
and