EM6607 EM Microelectronic, EM6607 Datasheet - Page 23

• Manufacturer Part Number: EM6607
• Description: Ultra-low power microcontroller
• Manufacturer: EM Microelectronic

10 Interrupt Controller
The EM6607 has 12 different interrupt sources, each of which is maskable. These are:
For an interrupt to the CPU to be generated, the interrupt request flag must be set (INTxx), and the corresponding mask
register bit must be set to 1 (Mxx), the general interrupt enable flag (INTEN) must also be set to 1. The interrupt request can
be masked by the corresponding interrupt mask registers MPortx for each input interrupt and by PSF0 ,PSF1 and MTim for
internal interrupts. At initial reset the interrupt mask bits are set to 0. INTEN bit is set automatically to 1 by Halt Instruction
except when starting the Automatic SWB transfer (see Serial Write Buffer (SWB) chapter 11)
The CPU is interrupted when one of the interrupt request flags is set to 1 in register IntRq and the INTEN bit is enabled in
the control register CIRQD. INTTE and INTPR flags are cleared automatically after a read of the IntRq register. The other
two interrupt flags INTPA (IRQ from PortA) and INTPC (IRQ from PortC) in the IntRq register are cleared only after reading
the corresponding Port interrupt request registers IRQpA and IRQpC. At the Power on reset and in SLEEP mode the INTEN
bit is also set to 0 therefore not allowing any interrupt requests to the CPU until it is set to 1 by software.
Since the CPU has only one interrupt subroutine and because the IntRq register is cleared after reading, the CPU does not
miss any of the interrupt requests which come during the interrupt service routine. If any occur during this time a new
interrupt will be generated as soon as the CPU comes out of the current interrupt subroutine. Interrupt priority can be
controlled through software by deciding which flag in the IntRq register should be serviced first.
For SWB interactive mode interrupt see section 11.0 Serial Write Buffer.
10.1 Interrupt control registers
Table 36.
* Write bit 2 only if SLmask=1
If the SLEEP flag is written with 1 then the EM6607 goes immediately into SLEEP mode (SLmask was at 1).
Copyright © 2005, EM Microelectronic-Marin SA
Bit
3
2
1
0
2
Internal (3)
External (9)
Main Interrupt request register - IntRq (Read Only)*
R
Name
INTPR
INTTE
INTPC
INTPA
SLEEP
Reset
0
0
0
0
0
- PortA PA3..PA0 inputs
- PortC PC3..PC0 inputs
- Combined AND of PortA * PortC
- Prescaler (32Hz / 8Hz / 1Hz)
- Timer/Event counter
- SWB in interactive mode
R/W
R
R
R
R
W*
Description
Prescaler interrupt request
Timer/counter interrupt request
PortC Interrupt request
PortA Interrupt request
SLEEP mode flag
23
www.emmicroelectronic.com
EM6607