LM3S3759 Luminary Micro, Inc, LM3S3759 Datasheet - Page 27

• Manufacturer Part Number: LM3S3759
• Description: Lm3s3759 Arm Microcontroller
• Manufacturer: Luminary Micro, Inc

June 02, 2008
■
■
■
–
ARM FiRM-compliant Watchdog Timer
–
–
–
–
–
–
Synchronous Serial Interface (SSI)
–
–
–
–
–
–
–
–
UART
–
–
–
–
–
–
–
–
16-bit PWM mode
•
32-bit down counter with a programmable load register
Separate watchdog clock with an enable
Programmable interrupt generation logic with interrupt masking
Lock register protection from runaway software
Reset generation logic with an enable/disable
User-enabled stalling when the controller asserts the CPU Halt flag during debug
Two SSI modules, each with the following features:
Master or slave operation
Programmable clock bit rate and prescale
Separate transmit and receive FIFOs, 16 bits wide, 8 locations deep
Programmable interface operation for Freescale SPI, MICROWIRE, or Texas Instruments
synchronous serial interfaces
Programmable data frame size from 4 to 16 bits
Internal loopback test mode for diagnostic/debug testing
Direct memory access (DMA)
Three fully programmable 16C550-type UARTs with IrDA support
Separate 16x8 transmit (TX) and 16x12 receive (RX) FIFOs to reduce CPU interrupt service
loading
Programmable baud-rate generator allowing speeds up to 3.125 Mbps
Programmable FIFO length, including 1-byte deep operation providing conventional
double-buffered interface
FIFO trigger levels of 1/8, 1/4, 1/2, 3/4, and 7/8
Standard asynchronous communication bits for start, stop, and parity
False-start-bit detection
Line-break generation and detection
Simple PWM mode with software-programmable output inversion of the PWM signal
Preliminary
LM3S3759 Microcontroller
27