rsa6351p Yamatake Corporation, rsa6351p Datasheet - Page 4

• Manufacturer Part Number: rsa6351p
• Description: Single Loop Controller
• Manufacturer: Yamatake Corporation

Event
Event type
G shows that the ON/
OFF is changed at
this value.
shows that the ON/
OFF is changed at
a point that "1U" is
added to this value.
The event is turned ON when any change in PV corresponding to increase/decrease in MV (Manipulated
variable) is not observed.
This event is used to detect any fault of final control devices.
G Setting items
G Operation specifications
G CAUTION
Heat control
The event is turned ON when any change in PV corresponding to increase/decrease in MV (Manipulated
variable) is not observed.
This event is used to detect any fault of final control devices.
G Setting items
G Operation specifications
G CAUTION
Heat control
Main setting
Sub-setting
PV to be used
Main setting
• Main setting: MV (Manipulated variable)
• Sub-setting: PV
• ON delay time: Diagnosis time
The event is turned ON when the value does not reach the PV set in the sub-setting within the diagnosis
time (ON delay time) even though the MV exceeding the main setting is held.
When setting the ON delay, it is necessary to put in "Multi-function setup".
The default setting of the ON delay before shipment is 0.0s.
• Main setting: MV (Manipulated variable)
• Sub-setting: Change in PV from the point that the MV exceeds the main setting.
• ON delay time: Diagnosis time
The event is turned ON when the MV exceeding the main setting is held (conditions 2) and the PV does
not reach the value that the sub-setting is added to (subtracted from) the PV at the point where the MV
exceeds the main setting within the diagnosis time (ON delay time) (conditions 1).
When setting the ON delay, it is necessary to put in "Multi-function setup".
The default setting of the ON delay before shipment is 0.0s.
as reference
MV
PV
On delay is started when conditions 1 and 2 are saisfied.
MV
PV
EV
ON delay is started when conditions 1 and 2 are satisfied.
EV
Area satisfying
conditions 1
Direct action
Direct action
Area satisfying
conditions 2
Conditions 3
Area satisfying
conditions 2
Conditions 3
ON delay
set time
ON delay
set time
Area satisfying
conditions 1
ON
ON
4
Time
Time
Time
Time
Time
Time
HYS
Loop diagnosis 1
Loop diagnosis 2
HYS
Sub-setting
(0 or more)
Cool control
Cool control
Main setting
PV to be used
Main setting
as reference
Sub-setting
ON delay is started when conditions 1 and 2 are satisfied.
MV
PV
MV
PV
EV
ON delay is started when conditions 1 and 2 are satisfied.
EV
Area satisfying
conditions 1
Reverse action
Reverse action
Area satsifying
conditions 2
Conditions 3
ON delay
Conditions 3
Area satisfying conditions 2
set time
ON delay
set time
Area satisfying
ON
conditions 1
ON
Time
Time
Time
Time
Time
Time
HYS
HYS
Sub-setting
(0 or more)