pca9518a NXP Semiconductors, pca9518a Datasheet

no-image

pca9518a

Manufacturer Part Number
pca9518a
Description
Pca9518a Expandable 5-channel I?c-bus Hub
Manufacturer
NXP Semiconductors
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
pca9518aPW
Manufacturer:
TI
Quantity:
2 197
Part Number:
pca9518aPW
Manufacturer:
TI/德州仪器
Quantity:
20 000
1. General description
1.
Only four ports per device are available if individual Enable is required.
The PCA9518A is a CMOS integrated circuit intended for application in I
SMBus systems.
While retaining all the operating modes and features of the I
extension of the I
enabling virtually an unlimited number of buses of 400 pF.
The I
Using the PCA9518A enables the system designer to divide the bus into an unlimited
number of segments off of a hub where any segment to segment transition sees only one
repeater delay and is multiple master capable on each segment.
Using multiple PCA9518A parts, any width hub (in multiples of five)
using the expansion pins.
The PCA9518A is a wider voltage range (2.3 V to 3.6 V) version of the PCA9518 and also
improves partial power-down performance, keeping I
state when V
A PCA9518 cluster cannot be put in series with a PCA9515/16 or with another
PCA9518 cluster. Multiple PCA9518 devices can be grouped with other PCA9518
devices into any size cluster thanks to the EXPxxxn pins that allow the I
be sent/received from/to one PCA9518 to/from another PCA9518 within the cluster. Since
there is no direction pin, slightly different ‘legal’ low voltage levels are used to avoid
lock-up conditions between the input and the output of individual repeaters in the cluster.
A ‘regular LOW’ applied at the input of any of the PCA9518 devices will then be
propagated as a ‘buffered LOW’ with a slightly higher LOW value to all enabled outputs in
the PCA9518 cluster. When this ‘buffered LOW’ is applied to a PCA9515 and PCA9516 or
separate PCA9518 cluster (not connected via the EXPxxxn pins) in series, the second
PCA9515 and PCA9516 or PCA9518 cluster will not recognize it as a ‘regular LOW’ and
will not propagate it as a ‘buffered LOW’ again. The PCA9510/9511/9513/9514 and
PCA9512 cannot be used in series with the PCA9515 and PCA9516 or PCA9518 either,
but can be used in series with themselves since they use shifting instead of static offsets
to avoid lock-up conditions. This note is applicable to the ‘A’ versions of these devices
also.
PCA9518A
Expandable 5-channel I
Rev. 01 — 6 June 2007
2
C-bus capacitance limit of 400 pF restricts the number of devices and bus length.
DD
is below 2.0 V.
2
C-bus by buffering both the data (SDA) and the clock (SCL) lines, thus
2
C-bus hub
2
C-bus I/O pins in high-impedance
2
C-bus system, it permits
1
Product data sheet
can be implemented
2
2
C-bus signals to
C-bus and

Related parts for pca9518a

pca9518a Summary of contents

Page 1

... Using multiple PCA9518A parts, any width hub (in multiples of five) using the expansion pins. The PCA9518A is a wider voltage range (2 3.6 V) version of the PCA9518 and also improves partial power-down performance, keeping I state when V A PCA9518 cluster cannot be put in series with a PCA9515/16 or with another PCA9518 cluster ...

Page 2

... Name Description SO20 plastic small outline package; 20 leads; body width 7.5 mm TSSOP20 plastic thin shrink small outline package; 20 leads; body width 4.4 mm Rev. 01 — 6 June 2007 PCA9518A 2 Expandable 5-channel I C-bus hub 2 C-bus devices and multiple masters Version SOT163-1 SOT360-1 © NXP B.V. 2007. All rights reserved. ...

Page 3

... SDA0 SDA1 SDA2 EN1 EN2 Fig 1. Block diagram of PCA9518A A more detailed view of Fig 2. Buffer detail The output pull-down voltage of each internal buffer is set for approximately 0.5 V, while the input threshold of each internal buffer is set about 0.07 V lower, when the output is internally driven LOW. This prevents a lock-up condition from occurring. ...

Page 4

... Rev. 01 — 6 June 2007 PCA9518A Expandable 5-channel I 1 EXPSCL1 EXPSCL2 2 SCL0 3 4 SDA0 5 SCL1 PCA9518APW SDA1 6 EN1 7 8 SCL2 SDA2 002aac529 Fig 4. Pin configuration for TSSOP20 © NXP B.V. 2007. All rights reserved. 2 ...

Page 5

... The PCA9518A CMOS integrated circuit contains five multi-directional, open-drain buffers specifically designed to support the standard low-level contention arbitration of the 2 I C-bus. Except during arbitration or clock stretching, the PCA9518A acts like a pair of non-inverting, open-drain buffers, one for SDA and one for SCL. Refer to 6.1 Enable The enable pins EN1 through EN4 are active HIGH and have internal pull-up resistors ...

Page 6

... V disabled; not connected SDA4 SCL4 Only two of the five channels on the PCA9518A Device 2 are being used. EN3 and EN4 are connected to V channels 3 and 4 and/or SDA3/SCL3 and SDA4/SCL4 are pulled C-bus port, but if unused then it must be pulled Fig 5 ...

Page 7

... PCA9518A to 0.5 V until after the delay of the circuit which determines that it was the last to rise, then it is allowed to rise above the 0.5 V level driven by the PCA9518A. Considering the bus 0 SDA to be the last one to go above 0.4 V, then the EXPSDA1 returns to HIGH after the EXPSDA2 is HIGH and either the bus 0 SDA rise time or, when the bus 0 SDA reaches 0 ...

Page 8

... PLH2 PLH1 t PLH2 V of slave OL t PLH of the devices on Bus below the V characteristics” recognized by the PCA9518A and then Rev. 01 — 6 June 2007 PCA9518A Expandable 5-channel clock cycle V of PCA9518A OL t stretch V of PCA9518A OL ...

Page 9

... Voltages with respect to pin V PCA9518A_1 Product data sheet Limiting values Parameter supply voltage 2 I C-bus voltage input current total power dissipation storage temperature ambient temperature . SS Rev. 01 — 6 June 2007 PCA9518A Expandable 5-channel I Conditions Min Max [ 0 [1] SCL or SDA 0.5 +6 ...

Page 10

... SCL, SDA 0 guaranteed by design 0.2 V; EN1 to EN4 3 EXPxxxn EXPxxxn V = 0.2 V; EXPxxxn 3 Rev. 01 — 6 June 2007 PCA9518A Expandable 5-channel I Min Typ 3.0 3 [2] 0.5 - [3] 0 ...

Page 11

... SCL, SDA 0 guaranteed by design 0.2 V; EN1 to EN4 2 EXPxxxn EXPxxxn V = 0.2 V; EXPxxxn 2 Rev. 01 — 6 June 2007 PCA9518A Expandable 5-channel I Min Typ 2.3 2 [2] 0.5 - [3] 0 ...

Page 12

... The SDA and SCL outputs have edge rate control circuits DD DD for the EXPSDA1 or EXPSCL1, and the rise time constant from DD for the SDA or SCL output. All of these rise times are RC time constants determined by the DD Rev. 01 — 6 June 2007 PCA9518A Expandable 5-channel I Min Typ [2][3] 105 202 [2][4] ...

Page 13

... SDA or SCL output. All of these rise times are RC time constants determined by the DD 0.7V DD input SDA or SCL t PHL t PHL1 EXPSDA1 or EXPSCL1 0. PHL2 EXPSDA2 or EXPSCL2 t PHL1 0.7V output SDA or SCL 0.52 V Rev. 01 — 6 June 2007 PCA9518A Expandable 5-channel I Min Typ [2][3] 105 202 [2][4] 110 259 109 193 Figure 7 130 153 Figure 7 160 234 Figure 7 58 110 - 0 ...

Page 14

... GENERATOR load resistor; 1.1 k for I C-bus, and 500 load capacitance includes jig and probe capacitance; 100 pF for I L EXPxxxn termination resistance should be equal Rev. 01 — 6 June 2007 PCA9518A Expandable 5-channel DUT 002aac532 for EXPxxxn ...

Page 15

... 0.49 0.32 13.0 7.6 10.65 1.27 0.36 0.23 12.6 7.4 10.00 0.019 0.013 0.51 0.30 0.419 0.05 0.014 0.009 0.49 0.29 0.394 REFERENCES JEDEC JEITA MS-013 Rev. 01 — 6 June 2007 PCA9518A Expandable 5-channel detail 1.1 1.1 1.4 0.25 0.25 0.4 1.0 0.043 0.043 0.055 0.01 0.01 0.016 0.039 ...

Page 16

... PCA9518A_1 Product data sheet 2.5 scale (1) ( 0.30 0.2 6.6 4.5 0.65 0.19 0.1 6.4 4.3 REFERENCES JEDEC JEITA MO-153 Rev. 01 — 6 June 2007 PCA9518A Expandable 5-channel detail 6.6 0.75 0.4 1 0.2 0.13 6.2 0.50 0.3 EUROPEAN PROJECTION ...

Page 17

... Solder bath specifications, including temperature and impurities PCA9518A_1 Product data sheet Expandable 5-channel I Rev. 01 — 6 June 2007 PCA9518A 2 C-bus hub © NXP B.V. 2007. All rights reserved ...

Page 18

... Lead-free process (from J-STD-020C) Package reflow temperature ( C) 3 Volume (mm ) < 350 260 260 250 Figure 11. Rev. 01 — 6 June 2007 PCA9518A Expandable 5-channel I Figure 11) than a PbSn process, thus 350 220 220 350 to 2000 > 2000 260 260 250 245 245 245 © ...

Page 19

... ElectroStatic Discharge Human Body Model Input/Output Inter-Integrated Circuit bus Machine Model Resistor Capacitor network System Management Bus Data sheet status Product data sheet Rev. 01 — 6 June 2007 PCA9518A 2 Expandable 5-channel I peak temperature 001aac844 Change notice Supersedes - - © NXP B.V. 2007. All rights reserved. ...

Page 20

... Notice: All referenced brands, product names, service names and trademarks are the property of their respective owners C-bus — logo is a trademark of NXP B.V. http://www.nxp.com salesaddresses@nxp.com Rev. 01 — 6 June 2007 PCA9518A 2 Expandable 5-channel I C-bus hub © NXP B.V. 2007. All rights reserved ...

Page 21

... Please be aware that important notices concerning this document and the product(s) described herein, have been included in section ‘Legal information’. © NXP B.V. 2007. For more information, please visit: http://www.nxp.com For sales office addresses, please send an email to: salesaddresses@nxp.com PCA9518A 2 C-bus hub All rights reserved. Date of release: 6 June 2007 Document identifier: PCA9518A_1 ...

Related keywords