ad420-32-reel Analog Devices, Inc., ad420-32-reel Datasheet - Page 10

• Manufacturer Part Number: ad420-32-reel
• Description: Serial Input 16-bit 4 Ma-20 Ma, 0 Ma-20 Ma Dac
• Manufacturer: Analog Devices, Inc.

AD420
AD420 PROTECTION
TRANSIENT VOLTAGE PROTECTION
The AD420 contains ESD protection diodes which prevent
damage from normal handling. The industrial control environ-
ment can, however, subject I/O circuits to much higher tran-
sients. In order to protect the AD420 from excessively high
voltage transients such as those specified in IEC 801, external
power diodes and a surge current limiting resistor may be re-
quired, as shown in Figure 14. The constraint on the resistor is
that during normal operation the output voltage level at I
must remain within its voltage compliance limit
and the two protection diodes and resistor must have appropri-
ate power ratings.
Figure 14. Output Transient Voltage Protection
(I
OUT
AD420
(Rp + R
GND
V
V
CC
CC
I
OUT
LOAD
)
R
V
P
CC
– 2.5 V)
R
LOAD
OUT
–10–
BOARD LAYOUT AND GROUNDING
The AD420 ground pin, designated GND, is the “high quality”
ground reference point for the device. Any external loads on the
REF OUT and V
this reference point. Analog and digital ground currents should
not share a common path. Each signal should have an appropri-
ate analog or digital signal return routed close to it. Using this
approach, signal loops enclose a small area, minimizing the
inductive coupling of noise. Wide PC tracks, large gauge wire,
and ground planes are highly recommended to provide low
impedance signal paths.
POWER SUPPLIES AND DECOUPLING
The AD420 supply pins, V
be decoupled to GND with 0.1 F capacitors to eliminate high
frequency noise that may otherwise get coupled into the analog
system. High frequency ceramic capacitors are recommended.
The decoupling capacitors should be located in close proximity
to the pins and the ground line to have maximum effect. Further
reductions in noise, and improvements in performance, may be
achieved by using a larger value capacitor on the V
OUT
pins of the AD420 should be returned to
CC
(Pin 23) and V
LL
(Pin 2), should
LL
pin.
REV. F