mc68hc05bd3 Freescale Semiconductor, Inc, mc68hc05bd3 Datasheet - Page 71

• Manufacturer Part Number: mc68hc05bd3
• Description: Mc68hc05bd3d Microcontroller
• Manufacturer: Freescale Semiconductor, Inc

8.4
The incoming signals can be either separate HSYNC and VSYNC or composite sync through
HSYNC input. Polarity correction is performed before the sync signals go any further into the
system. The sync pulse detection block continuously monitors the signals to see if the signals are
active. If the signals are not active, the circuit switches to output the internally generated sync
signals. This will protect the circuits behind from being damaged by inactive signals.
A typical monitor system operation is summarized in Figure 8-6.
Note:
Note:
MC68HC05BD3
User is required to check the HDET and VDET at VSIN=0 first. If either or both are not
detected, user then set VSIN=1 to check HDET and VDET. It is because if the incoming
signal is a valid composite signal, HDET and VDET are both read 1 even VSIN=1.
Each time if VDET is not detected when VSIN=1, user needs to clear VSIN to check
VDET. If VDET is still not detected, user then set VSIN to check them again to decide
what mode it is.
System Operation
SYNC SIGNAL PROCESSOR
TPG
8-11
8