at75c220 ATMEL Corporation, at75c220 Datasheet - Page 23

• Manufacturer Part Number: at75c220
• Description: Smart Internet Appliance Processor Siap
• Manufacturer: ATMEL Corporation

Figure 7 shows a write and a read to memory 0 followed by
a read and a write to memory 1. SMC_CSR0 is pro-
grammed for zero wait states with BAT = 0 and DFT = 0.
SMC_CSR1 is programmed for zero wait states with BAT =
1 and DFT = 1. SMC_MCR is programmed for normal
reads from all memories
The write to memory 0 is a byte access and, therefore, only
one NWE strobe is active. As BAT = 0, they are configured
as write strobes and have the same timing as NWR.
The memory 0 read immediately follows the write as early
reads are not configured and an early read wait state is not
required. As early reads are not configured, the read strobe
pulse is one-half clock cycle long.
Figure 7. Write and Read to Memory 0, Read and Write to Memory 1
D (MEM)
D (SIAP)
NWE0
NWE1
NWE2
NWE3
NSOE
NCE0
NCE1
BCLK
NWR
A
Chip Select
Wait State
There is a chip select change wait state between the mem-
ory 0 write and the memory 1 read. The new address is
output at the end of the memory 0 access but the strobes
are delayed for one clock cycle.
The write to memory 1 is a half-word access to an odd half-
word address and, therefore, NWE2 and NWE3 are active.
As BAT = 1, they are configured as byte select signals and
have the same timing as NCE.
As DFT = 1 for memory 1, a wait state is implemented
between the read and write to provide time for the memory
to stop driving the data bus. DFT wait states are only imple-
mented at the end of read accesses.
The read from memory 1 is a byte access to an address
with a byte offset of 2 and, therefore, only NWE2 is active.
Data Float
Wait State
23