lan9117 Standard Microsystems Corp., lan9117 Datasheet - Page 109

• Manufacturer Part Number: lan9117
• Description: Lan9117 High-performance Single-chip 10/100 Non-pci Ethernet Controller
• Manufacturer: Standard Microsystems Corp.

High Performance Single-Chip 10/100 Non-PCI Ethernet Controller
Datasheet
SMSC LAN9117
5.5.1
BITS
6-0
15
14
13
12
10
11
9
8
7
DESCRIPTION
Reset. 1 = software reset. Bit is self-clearing. For best results, when setting
this bit do not set other bits in this register.
Loopback. 1 = loopback mode, 0 = normal operation
Speed Select. 1 = 100Mbps, 0 = 10Mbps. Ignored if Auto Negotiation is
enabled (0.12 = 1).
Auto-Negotiation Enable. 1 = enable auto-negotiate process (overrides
0.13 and 0.8) 0 = disable auto-negotiate process.
Power Down. 1 = General power down-mode, 0 = normal operation.
Note:
Reserved
Restart Auto-Negotiate. 1 = restart auto-negotiate process 0 = normal
operation. Bit is self-clearing.
Duplex Mode. 1 = full duplex, 0 = half duplex. Ignored if Auto Negotiation
is enabled (0.12 = 1).
Collision Test. 1 = enable COL test, 0 = disable COL test
Reserved
Basic Control Register
Note 5.2
Index (In Decimal):
After this bit is cleared, the PHY may auto-negotiate with it's
partner station. This process may take a few seconds to complete.
Once auto-negotiation is complete, bit 5 of the PHY's Basic Status
Register will be set.
This default value of this bit is determined by Pin 74 "SPEED_SEL". Please refer to the
pin description section for more details
0
DATASHEET
109
Size:
16-bits
RW/SC
RW/SC
TYPE
RW
RW
RW
RW
RW
RW
RO
RO
Revision 1.5 (07-11-08)
See
See
DEFAULT
Note 5.2
Note 5.2
0
0
0
0
0
0
0
0