sab-c167cs-l16m3v Infineon Technologies Corporation, sab-c167cs-l16m3v Datasheet - Page 74

• Manufacturer Part Number: sab-c167cs-l16m3v
• Description: 16-bit Single-chip Microcontroller
• Manufacturer: Infineon Technologies Corporation

Bus Cycle Control via READY Input
The duration of an external bus cycle can be controlled by the external circuitry via the
READY input signal.
Synchronous READY permits the shortest possible bus cycle but requires the input
signal to be synchronous to the reference signal CLKOUT.
Asynchronous READY puts no timing constraints on the input signal but incurs one
waitstate minimum due to the additional synchronization stage.
Table 19
Parameter
Input setup time to CLKOUT rising edge
Valid for: READY input
Input hold time after CLKOUT rising edge
Valid for: READY input
Asynchronous READY input low time
Notes (Valid for
1)
2)
3)
4)
5)
Data Sheet
Cycle as programmed, including MCTC waitstates (Example shows 0 MCTC WS).
Multiplexed bus modes have a MUX waitstate added after a bus cycle, and an additional MTTC waitstate may
be inserted here. For a multiplexed bus with MTTC waitstate this delay is 2 CLKOUT cycles, for a
demultiplexed bus without MTTC waitstate this delay is zero.
These timings are given for test purposes only, in order to assure recognition at a specific clock edge.
If the Asynchronous READY signal does not fulfill the indicated setup and hold times with respect to CLKOUT,
it must fulfill
Proper deactivation of READY is guaranteed if READY is deactivated in response to the trailing (rising) edge
of the corresponding command (RD or WR).
READY sampled HIGH at this sampling point generates a READY controlled waitstate,
READY sampled LOW at this sampling point terminates the currently running bus cycle.
If the next following bus cycle is READY controlled, an active READY signal must be disabled before the first
valid sample point for the next bus cycle. This sample point depends on the MTTC waitstate of the current
cycle, and on the MCTC waitstates and the ALE mode of the next following cycle. If the current cycle uses a
multiplexed bus the intrinsic MUX waitstate adds another CLKOUT cycle to the READY deactivation time.
tc
Table 19
27
READY Timing (Operating Conditions apply)
in order to be safely synchronized.
and
Figure
21)
3)
70
Symbol
tc
tc
tc
25
26
27
CC
CC
CC
16
0
tc
5
min
+
tc
Limits
C167CS-L16M3V
25
–
–
–
max
Low Power
V1.0, 2001-10
Unit
ns
ns
ns