m95512-dr STMicroelectronics, m95512-dr Datasheet - Page 13

• Manufacturer Part Number: m95512-dr
• Description: 512kbit Serial Spi Bus Eeprom With High Speed Clock
• Manufacturer: STMicroelectronics

M95512-W, M95512-R, M95512-DR
4.1.4
4.2
4.3
Power-down
During power-down (continuous decrease in V
defined in
●
●
Active Power and Standby Power modes
When Chip Select (S) is low, the device is selected, and in the Active Power mode. The
device consumes I
When Chip Select (S) is high, the device is deselected. If a Write cycle is not currently in
progress, the device then goes in to the Standby Power mode, and the device consumption
drops to I
Hold condition
The Hold (HOLD) signal is used to pause any serial communications with the device without
resetting the clocking sequence.
During the Hold condition, the Serial Data Output (Q) is high impedance, and Serial Data
Input (D) and Serial Clock (C) are Don’t Care.
To enter the Hold condition, the device must be selected, with Chip Select (S) low.
Normally, the device is kept selected, for the whole duration of the Hold condition.
Deselecting the device while it is in the Hold condition, has the effect of resetting the state of
the device, and this mechanism can be used if it is required to reset any processes that had
been in progress.
The Hold condition starts when the Hold (HOLD) signal is driven low at the same time as
Serial Clock (C) already being low (as shown in
The Hold condition ends when the Hold (HOLD) signal is driven high at the same time as
Serial Clock (C) already being low.
Figure 5
with Serial Clock (C) being low.
Figure 5.
HOLD
deselected (Chip Select (S) should be allowed to follow the voltage applied on V
in Standby Power mode (that is there should not be any internal write cycle in
progress).
C
also shows what happens if the rising and falling edges are not timed to coincide
CC1
Table 8
Hold condition activation
.
and
CC
, as specified in
Table
10), the device must be:
Doc ID 11124 Rev 12
Condition
Hold
Table
15.
CC
Figure
below the minimum V
5).
Condition
Hold
CC
Operating features
operating voltage
CC
AI02029D
13/47
)