m95512-dr STMicroelectronics, m95512-dr Datasheet - Page 27

• Manufacturer Part Number: m95512-dr
• Description: 512kbit Serial Spi Bus Eeprom With High Speed Clock
• Manufacturer: STMicroelectronics

M95512-W, M95512-R, M95512-DR
6.9
Figure 16. Read Lock Status sequence
6.10
Read Lock Status (available only in M95512-DR devices)
The Read Lock Status instruction is used to read the lock status. To send this instruction to
the device, Chip Select (S) first has to be driven low. The bits of the instruction byte and
address bytes are then shifted in on Serial Data input (D). Address bit A10 must be 1, all
other address bits are Don't Care. The Lock bit is the LSB (least significant bit) of the byte
read on Serial Data output (Q). It is at ‘1’ when the lock is active and at ‘0’ when the lock is
not active. If Chip Select (S) continues to be driven low, the same data byte is shifted out.
The read cycle is terminated by driving Chip Select (S) high.
The instruction sequence is shown in
Lock ID (available only in M95512-DR devices)
The Lock ID instruction permanently locks the Identification Page in read-only mode. Before
this instruction can be accepted, a Write Enable (WREN) instruction must have been
executed. The Lock ID instruction is issued by driving Chip Select (S) low, sending the
instruction code, the address and a data byte on Serial Data input (D), and driving Chip
Select (S) high. In the address sent, A10 must be equal to 1, all other address bits are Don't
Care. The data byte sent must be equal to the binary value xxxx xx1x, where x = Don't Care.
Chip Select (S) must be driven high after the rising edge of Serial Clock (C) that latches in
the eighth bit of the data byte, and before the next rising edge of Serial Clock (C). Otherwise,
the Lock ID instruction is not executed.
Driving Chip Select (S) high at a byte boundary of the input data triggers the self-timed write
cycle whose duration is t
shown in
Figure
17.
W
(specified in
Doc ID 11124 Rev 12
Figure
Table 17
16.
and
Table
18). The instruction sequence is
Instructions
27/47