c8051t617 Silicon Laboratories, c8051t617 Datasheet - Page 15

• Manufacturer Part Number: c8051t617
• Description: Mixed Signal Byte-programmable Eprom Mcu
• Manufacturer: Silicon Laboratories

1.
C8051T61x devices are fully integrated mixed-signal System-on-a-Chip MCUs. Highlighted features are
listed below. Refer to Table 1.1 for specific product feature selection.
•
•
•
•
•
•
•
•
•
•
•
•
•
With on-chip Power-On Reset, V
are truly stand-alone System-on-a-Chip solutions. User software has complete control of all peripherals,
and may individually shut down any or all peripherals for power savings.
Code written for the C8051T61x family of processors will run on the C8051F31x family of Mixed-signal ISP
Flash microcontrollers, providing a quick, cost-effective way to develop code without requiring special
emulator circuitry. The C8051T61x processors include Silicon Laboratories’ 2-Wire C2 Debug and Pro-
gramming interface, which allows non-intrusive (uses no on-chip resources), full speed, in-circuit debug-
ging using the production MCU installed in the final application. This debug logic supports inspection of
memory, viewing and modification of special function registers, setting breakpoints, single stepping, run
and halt commands. All analog and digital peripherals are fully functional while debugging using C2. The
two C2 interface pins can be shared with user functions, allowing in-system debugging without occupying
package pins.
Each device is specified for 1.8-to-3.6 V operation over the industrial temperature range (–45 to +85 °C).
An internal LDO is used to supply the processor core voltage at 1.8 V. The Port I/O and RST pins are toler-
ant of input signals up to 5 V. The C8051T61x are available in 32-pin LQFP, 28-pin QFN, and 24-pin QFN
packages. See Table 1.1 for ordering part numbers. Note: QFN packages are also referred to as MLP or
MLF packages.
High-speed pipelined 8051-compatible microcontroller core (up to 25 MIPS)
In-system, full-speed, non-intrusive debug interface (on-chip)
C8051F31x ISP Flash devices are available for quick in-system code development
True 10-bit 500 ksps 23-channel single-ended ADC with analog multiplexer (C8051T610/1/2/3/6)
Precision calibrated 24.5 MHz internal oscillator
16 kB (C8051T610/1/6/7) or 8 kB (C8051T612/3/4/5) byte-programmable EPROM
1280 bytes of on-chip RAM
SMBus/I
Four general-purpose 16-bit timers
Programmable Counter/Timer Array (PCA) with five capture/compare modules and Watchdog Timer
function
On-chip Power-On Reset, V
On-chip Voltage Comparators (2)
29/25/21 Port I/O
System Overview
2
C, Enhanced UART, and SPI serial interfaces implemented in hardware
DD
DD
Monitor, and Temperature Sensor
monitor, Watchdog Timer, and clock oscillator, the C8051T61x devices
Rev. 0.3
C8051T610/1/2/3/4/5/6/7
15