MC68HC908KX2 MOTOROLA [Motorola, Inc], MC68HC908KX2 Datasheet - Page 125
MC68HC908KX2
Manufacturer Part Number
MC68HC908KX2
Description
Microcontrollers
Manufacturer
MOTOROLA [Motorola, Inc]
Datasheet
1.MC68HC908KX2.pdf
(311 pages)
- Current page: 125 of 311
- Download datasheet (2Mb)
7.5.7 Trimming Frequency on the Internal Clock Generator
7.6 Low-Power Modes
MC68HC908KX8 • MC68HC908KX2 • MC68HC08KX8 — Rev. 1.0
MOTOROLA
The unadjusted frequency of the low-frequency base clock (IBASE),
when the comparators in the frequency comparator indicate zero error,
will vary as much as 25 percent due to process, temperature, and
voltage dependencies. These dependencies are in the voltage and
current references, the offset of the comparators, and the internal
capacitor.
The method of changing the unadjusted operating point is by changing
the size of the capacitor. This capacitor is designed with 639 equally
sized units. Of that number, 384 of these units are always connected.
The remaining 255 units are put in by adjusting the ICG trim factor
(TRIM). The default value for TRIM is $80, or 128 units, making the
default capacitor size 512. Each unit added or removed will adjust the
output frequency by about 0.195 percent of the unadjusted frequency
(adding to TRIM will decrease frequency). Therefore, the frequency of
IBASE can be changed to 25 percent of its unadjusted value, which is
enough to cancel the process variability mentioned before.
The best way to trim the internal clock is to use the timer to measure the
width of an input pulse on an input capture pin (this pulse must be
supplied by the application and should be as long or wide as possible).
Considering the prescale value of the timer and the theoretical (zero
error) frequency of the bus (307.2 kHz *N/4), the error can be calculated.
This error, expressed as a percentage, can be divided by 0.195 percent
and the resultant factor added or subtracted from TRIM. This process
should be repeated to eliminate any residual error.
The WAIT and STOP instructions put the MCU in low power-
consumption standby modes.
Internal Clock Generator Module (ICG)
Internal Clock Generator Module (ICG)
Low-Power Modes
Technical Data
125
Related parts for MC68HC908KX2
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Motorola, Inc [VOLTAGE REGULATOR]
Manufacturer:
Motorola
Datasheet:
Part Number:
Description:
6367254 MOTOROLA SC (XSTRS/R F)
Manufacturer:
MOTOROLA [Motorola, Inc]
Datasheet:
Part Number:
Description:
MC1494LMotorola, Inc [MONOLITHIC FOUR-QUADRANT MULTIPLIER]
Manufacturer:
Motorola
Datasheet:
Part Number:
Description:
MC1466LMotorola, Inc [PRECISION WIDE RANGE VOLTAGE AND CURRENT REGULATOR]
Manufacturer:
Motorola
Datasheet:
Part Number:
Description:
MC145532DWMotorola, Inc [ADPCM Transcoder]
Manufacturer:
Motorola
Datasheet:
Part Number:
Description:
Silicon Controlled Rectifiers
Manufacturer:
MOTOROLA [Motorola, Inc]
Datasheet:
Part Number:
Description:
RF Power Field Effect Transistors N-Channel Enhancement-Mode Lateral MOSFETs
Manufacturer:
MOTOROLA [Motorola, Inc]
Datasheet:
Part Number:
Description:
RF POWER FIELD EFFECT TRANSISTORS
Manufacturer:
MOTOROLA [Motorola, Inc]
Datasheet:
Part Number:
Description:
LATERAL N-CHANNEL BROADBAND RF POWER MOSFETs
Manufacturer:
MOTOROLA [Motorola, Inc]
Datasheet:
Part Number:
Description:
RF POWER FIELD EFFECT TRANSISTOR
Manufacturer:
MOTOROLA [Motorola, Inc]
Datasheet:
Part Number:
Description:
RF LOW POWER TRANSISTOR NPN SILICON
Manufacturer:
MOTOROLA [Motorola, Inc]
Datasheet:
Part Number:
Description:
PLASTIC SURFACE MOUNT ZENER DIODES 1.5 WATTS 3.3-68 VOLTS
Manufacturer:
MOTOROLA [Motorola, Inc]
Datasheet:
Part Number:
Description:
OVERVOLTAGE TRANSIENT SUPPRESSOR
Manufacturer:
MOTOROLA [Motorola, Inc]
Datasheet:
Part Number:
Description:
TMOS POWER FET 15 AMPERES 60 VOLTS
Manufacturer:
MOTOROLA [Motorola, Inc]
Datasheet:
Part Number:
Description:
TMOS POWER FET LOGIC LEVEL 19 AMPERES 30 VOLTS RDS(on) = 0.099 OHM
Manufacturer:
MOTOROLA [Motorola, Inc]
Datasheet: