NCP1410_05 ONSEMI [ON Semiconductor], NCP1410_05 Datasheet
NCP1410_05
Related parts for NCP1410_05
NCP1410_05 Summary of contents
Page 1
NCP1410 250 mA Sync−Rect PFM Step−Up DC−DC Converter with Low−Battery Detector NCP1410 is a monolithic micropower high frequency Boost (step−up) voltage switching converter IC specially designed for battery operated hand−held electronic products up to 250 mA loading. It integrates Synchronous ...
Page 2
Input 1 OUT 150 pF 200 k Low Battery Sense Input Low Battery Open Drain Output Shutdown Open Drain Input MAXIMUM RATINGS (Note 1) Rating Device Power Supply (Pin 8) Input/Output Pins (Pin 1−5, Pin 7) Thermal ...
Page 3
ELECTRICAL CHARACTERISTICS unless otherwise noted.) Characteristics Operating Voltage Output Voltage Range (Adjusted by external feedback) Reference Voltage (C = 150 nF, under no loading, T REF Reference Voltage (C = 150 nF, under no loading, −40 C REF Reference Voltage ...
Page 4
V bat SHDN Chip SHDN Enable _ZCUR C SHDN _PWGONCE _CEN PFM 1 + _PFM FB − Voltage _V 4 REFOK Reference REF C REF 2 LBI NCP1410 ZLC + − CONTROL V DD ...
Page 5
TYPICAL OPERATING CHARACTERISTICS 1.212 V = 3.3 V OUT 1.208 = OUT = 1 1.204 REF 1 ...
Page 6
TYPICAL OPERATING CHARACTERISTICS 100 1 3 OUT = OUT ...
Page 7
TYPICAL OPERATING CHARACTERISTICS − 1 3.3 V OUT − OUT −3 1.0 10 OUTPUT LOADING CURRENT, I ...
Page 8
TYPICAL OPERATING CHARACTERISTICS = OUT LOAD = 33 mF) C OUT Upper Trace: Voltage at L pin, 2.0 V/Division X MiddleTrace Otuput Voltage Ripple, ...
Page 9
DETAILED OPERATION DESCRIPTIONS NCP1410 is a monolithic micropower high frequency step−up voltage switching converter IC specially designed for battery operated hand−held electronic products up to 250 mA loading. It integrates Synchronous Rectifier for improving efficiency as well as eliminating the ...
Page 10
Low−Battery Detection A comparator with 30 mV hysteresis is applied to perform the low−battery detection function. When pin 2 (LBI voltage, which can be defined by a resistor divider from the battery voltage, lower than the internal ...
Page 11
Components Placement Power components, i.e. input capacitor, inductor and output capacitor, must be placed as close together as possible. All connecting traces must be short, direct and thick. High current flowing and switching paths must be kept away from the ...
Page 12
GENERAL DESIGN PROCEDURES Switching mode converter design is considered as black magic to most engineers, some complicate empirical formulae are available for reference usage. Those formulae are derived form the assumption that the key components, i.e. power inductor and capacitors ...
Page 13
K PIN 0.08 (0.003) SEATING PLANE −T− 0.038 (0.0015 1.04 8X 0.041 3.20 0.126 0.65 6X 0.0256 *For additional information on our Pb−Free strategy and soldering details, please download ...
Page 14
Micro8 is a trademark of International Rectifier. ON Semiconductor and are registered trademarks of Semiconductor Components Industries, LLC (SCILLC). SCILLC reserves the right to make changes without further notice to any products herein. SCILLC makes no warranty, representation or guarantee ...