MK60DN512VLQ10 Freescale Semiconductor, MK60DN512VLQ10 Datasheet - Page 19

• Manufacturer Part Number: MK60DN512VLQ10
• Description: ARM Microcontrollers - MCU KINETIS 512K ENET
• Manufacturer: Freescale Semiconductor

Specifications of MK60DN512VLQ10

• Rohs: yes
• Core: ARM Cortex M4
• Processor Series: K60
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 100 MHz
• Program Memory Size: 512 KB
• Data Ram Size: 4 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 1.71 V to 3.6 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: LQFP-144
• Mounting Style: SMD/SMT

1. The analog supply current is the sum of the active or disabled current for each of the analog modules on the device. See
2. 100MHz core and system clock, 50MHz bus and FlexBus clock, and 25MHz flash clock . MCG configured for FEI mode.
3. 100MHz core and system clock, 50MHz bus and FlexBus clock, and 25MHz flash clock. MCG configured for FEI mode. All
4. Max values are measured with CPU executing DSP instructions.
5. 25MHz core and system clock, 25MHz bus clock, and 12.5MHz FlexBus and flash clock. MCG configured for FEI mode.
6. 2 MHz core, system, FlexBus, and bus clock and 1MHz flash clock. MCG configured for BLPE mode. All peripheral clocks
7. 2 MHz core, system, FlexBus, and bus clock and 1MHz flash clock. MCG configured for BLPE mode. All peripheral clocks
8. 2 MHz core, system, FlexBus, and bus clock and 1MHz flash clock. MCG configured for BLPE mode. All peripheral clocks
9. Data reflects devices with 128 KB of RAM. For devices with 64 KB of RAM, power consumption is reduced by 2 μA.
10. Includes 32kHz oscillator current and RTC operation.
5.2.5.1 Diagram: Typical IDD_RUN operating behavior
The following data was measured under these conditions:
Freescale Semiconductor, Inc.
I
Symbol
DD_VBAT
• MCG in FBE mode for 50 MHz and lower frequencies. MCG in FEE mode at greater
• USB regulator disabled
• No GPIOs toggled
• Code execution from flash with cache enabled
• For the ALLOFF curve, all peripheral clocks are disabled except FTFL
each module's specification for its supply current.
All peripheral clocks disabled.
peripheral clocks enabled.
disabled. Code executing from flash.
enabled but peripherals are not in active operation. Code executing from flash.
disabled.
than 50 MHz frequencies.
Average current when CPU is not accessing RTC
registers
Description
• @ 1.8V
• @ 3.0V
Table 6. Power consumption operating behaviors (continued)
• @ –40 to 25°C
• @ 70°C
• @ 105°C
• @ –40 to 25°C
• @ 70°C
• @ 105°C
K60 Sub-Family Data Sheet Data Sheet, Rev. 7, 02/2013.
Min.
—
—
—
—
—
—
0.71
1.01
2.82
0.84
1.17
3.16
Typ.
Max.
0.81
0.94
1.3
4.3
1.5
4.6
Unit
μA
μA
μA
μA
μA
μA
Notes
General
10
19