WizFi630 WIZnet, WizFi630 Datasheet - Page 69

• Manufacturer Part Number: WizFi630
• Description: WiFi / 802.11 Modules 802.11b/g/n WiFi Module
• Manufacturer: WIZnet

Specifications of WizFi630

• Rohs: yes
• Protocol Supported: 802.11 b/g/n
• Frequency Band: 2.4 GHz
• Data Rate: 150 Mbps
• Interface Type: UART
• Antenna Connector Type: U.FL
• Operating Supply Voltage: 3.3 V
• Maximum Operating Temperature: + 70 C
• Dimensions: 33 mm x 43 mm x 4.5 mm
• Minimum Operating Temperature: - 10 C

To OEM Installer
1. FCC ID on the final system must be labeled with “Contains FCC ID: XR2WIZ630WI” and
“Contains transmitter Module FCC ID: XR2WIZ630WI “
2. In the user manual, final system integrator must ensure that there is no instruction provided in the
user Manual to install or remove the transmitter module.
3. Transmitter module must be installed used in strict accordance with the Manufacturer’s instructions
as described in the user documentation that comes with the product. The user manual of the final
host system must contain the following statements: This device complies with Part 15 of the FCC rules.
Operation is subject to following
Two conditions: 1. this device may not cause harmful interference and 2. This device Must accept any
interference received including interference that may cause undesired operation of this device.
The changes or modifications not expressly approved by the party responsible for
Compliance could void the user’s authority to operate the equipment.
To comply with the FCC RF exposure compliance requirements, this device and its antenna must not
be co-located or operating to conjunction with any other antenna or transmitter, except if installed In
compliance with FCC Multi Transmitter procedures.
To inherit the modular approval, the antennas for this transmitter must be installed to provide a
Separation distance of at least 20cm from all persons and must not be co-located or operating in
Conjunction with any other antenna or transmitter.
Note:
The buyer of the module who will incorporate this module into his host must submit the final product
to the Manufacturer of the module and the MANUFACTURER OF THE MODULE WILL VERIFY that the
product is incorporated in host equipment in a way that is represented by the testing as shown in the
test report.
Note:
)
The module is used AP, Gateway, Household. (except PC.
69
© Copyright 2012 WIZnet Co., Ltd. All rights reserved.