KIT34708VMEVBE Freescale Semiconductor, KIT34708VMEVBE Datasheet - Page 19

• Manufacturer Part Number: KIT34708VMEVBE
• Description: Acceleration Sensor Development Tools 13x13 PWR MGMT AND UI
• Manufacturer: Freescale Semiconductor

Specifications of KIT34708VMEVBE

• Rohs: yes
• Tool Is For Evaluation Of: MC34708
• Sensing Axis: Single Axis
• Interface Type: I2C, SPI, USB
• Operating Voltage: 5 V
• Operating Current: 5 A
• Output Type: Analog, Digital

Table 6. KIT34708VMEVBE (Rev. B) Unpopulated Jumper Description Key
Freescale Semiconductor
Reference
Jumper
J72
J71
J62
J63
J64
J66
J67
J69
J70
ADIN9/ ADIN10 / ADIN11
PUMS 4 configuration
PUMS 5 configuration
ICTEST configuration
VGEN2 external PNP
General Description
Thermistor pull-down
MOSI configuration
BPTHERM supply
enablement
CS pull-up
selection
KIT34708VMEVBE Evaluation
Position
Shorted
Shorted
Shorted
Open
Open
Open
1-2
2-3
1-2
2-3
1-2
2-3
1-2
3-4
5-6
1-2
2-3
1-2
3-4
5-6
Tied to VCOREDIG (Check the MC34708 Data Sheet for further reference on the
power up sequence and default values)
Tied to ground (Check the MC34708 Data Sheet for further reference on the
power up sequence and default values)
Tied to VCOREDIG (Check the MC34708 Data Sheet for further reference on the
power up sequence and default values)
Tied to ground (Check the MC34708 Data Sheet for further reference on the
power up sequence and default values)
Tied to VCORE for test mode and Freescale use only
Tied to ground for normal operation and product applications
MOSI pin enabled for SPI communication
Tied to VCOREDIG for I
Tied to ground for I
CS pin is allowed to be controlled by connector J11. The device will be configured
for SPI mode
Tied to VCOREDIG. If connected at startup, the device will be configured for I
mode
Input to the linear regulator and the integrated PMOS for lower current
requirements on VGEN2
Base current drive pin for the external PNP when higher currents are required
from VGEN2
Connects the 5.0 V powered resistor-potentiometer divider to ADIN9 for voltage
measurements
Connects the 5.0 V powered resistor-potentiometer divider to ADIN11 for voltage
measurements
Connects the 5.0 V powered resistor-potentiometer divider to ADIN10 for voltage
measurements
No battery thermistor supply from PMIC
Battery thermistor divider supply, NTCREF, through a pull resistor
When using a battery with a thermistor
Compulsory connection when using a battery without a thermistor
Board, Rev. 2.0
2
C communication address 0001000
2
C communication address 0001001
Function
Setup Configuration
2
19
C