KIT34708VMEVBE Freescale Semiconductor, KIT34708VMEVBE Datasheet - Page 44

• Manufacturer Part Number: KIT34708VMEVBE
• Description: Acceleration Sensor Development Tools 13x13 PWR MGMT AND UI
• Manufacturer: Freescale Semiconductor

Specifications of KIT34708VMEVBE

• Rohs: yes
• Tool Is For Evaluation Of: MC34708
• Sensing Axis: Single Axis
• Interface Type: I2C, SPI, USB
• Operating Voltage: 5 V
• Operating Current: 5 A
• Output Type: Analog, Digital

6.11.2 Special RTC Commands and GPIO Commands
Freescale Semiconductor
•
•
•
•
When running in Script mode, special commands are added at the end of the list in the
Register section. These commands are:
6.
7.
8.
•
•
•
•
•
•
RTC Set Time of Computer Clock: Takes the value of the computer clock and
writes it in the RTC time register.
RTC Time Compare Between Computer Clock and the MC34708: Compares the
value of the MC34708 RTC with the time of the computer clock.
GPIO “x” Write High/Low State: Where “x” represents CS, GLBRST, STANDBY,
WDI and PWRON1. These commands simply configure the state of the listed pins.
GPIO “x” Read State: Where “x” represents CS, GLBRST, STANDBY, WDI,
PWRON1, RESETB, RESETBMCU, SDWNB, PWRON1 and INT. These commands
read the state of the listed pins.
Click the Create Command button in the Cmd and Group Iterations section.
The command will be saved with the characteristics specified in the Cmd and
Group Iterations section.
The software gives the possibility to iterate a bunch of commands that are saved
in a group. To do this, after creating a bunch of commands and selecting the
number of group iterations, click the Create Group button, and all the commands
will be saved under that specific group. After saving the commands into a group,
they will be removed from the command list and a new group will begin. Select the
Assign Name to Group check box to assign a specific name to a group. All
scripts must have at least one group in order to save them and all the commands
must belong to a group, even if the group consists of a single command.
After all the commands and groups have been created and saved, click the Save
Script button to save the file.
repeated
indicate if the read of a register is valid or not (as a decimal number). When the
script runs, a write command will compare the read value with these limits and
show if the command passed or failed. This is useful for example, for ADC
readings.
executed. It is given in milliseconds.
can select a specific one and delete it.
memory.
memory, after they have been saved to disk to start a new script file.
Command Iterations indicates the number of times the command will be
Command Limits is for Read commands. The user can set the limits that
The Command Delay box is to specify a determined delay after the command is
The Delete Command button shows a list of all the created commands. The user
The Delete All Groups button deletes all the created groups from the RAM
The New Script button removes all the commands and groups from the RAM
KIT34708VMEVBE Evaluation
Board, Rev. 2.0
Software
44