M28W320FCT70N6F NUMONYX, M28W320FCT70N6F Datasheet - Page 13

• Manufacturer Part Number: M28W320FCT70N6F
• Description: IC FLASH 32MBIT 70NS 48TSOP
• Manufacturer: NUMONYX

Specifications of M28W320FCT70N6F

• Format - Memory: FLASH
• Memory Type: FLASH - Nor
• Memory Size: 32M (2M x 16)
• Speed: 70ns
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-TSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2.7
2.8
2.9
2.10
2.11
Reset (RP)
The Reset input provides a hardware reset of the memory. When Reset is at V
memory is in reset mode: the outputs are high impedance and the current consumption is
minimized. After Reset all blocks are in the Locked state. When Reset is at V
in normal operation. Exiting reset mode the device enters read array mode, but a negative
transition of Chip Enable or a change of the address is required to ensure valid data outputs.
V
V
power supply for all operations (Read, Program and Erase).
V
V
independently from V
V
V
voltage range applied to the pin. The Supply Voltage V
V
If V
a voltage lower than V
V
sampled at the beginning of a Program or Erase; a change in its value after the operation
has started does not have any effect on Program or Erase, however for Double or
Quadruple Word Program the results are uncertain.
If V
be stable until the Program/Erase algorithm is completed (see
V
V
Note: Each device in a system should have V
capacitor close to the pin. See
widths should be sufficient to carry the required V
DD
DDQ
PP
PP
PP
SS
DD
DDQ
PP
SS
PP
PP
is both a control input and a power supply pin. The two functions are selected by the
can be applied in any order.
> V
is the reference for all voltage measurements.
provides the power supply to the internal core of the memory device. It is the main
provides the power supply to the I/O pins and enables all Outputs to be powered
Program supply voltage
is kept in a low voltage range (0V to 3.6V) V
is in the range 11.4V to 12.6V it acts as a power supply pin. In this condition V
ground
supply voltage
PP1
supply voltage
enables these functions (see
DD
PPLK
. V
DDQ
gives an absolute protection against program or erase, while
Figure 7: AC Measurement Load
can be tied to V
Table 15: DC
DD
DD
, V
PP
PP
or can use a separate supply.
DDQ
program and erase currents.
is seen as a control input. In this case
DD
Characteristics). V
and V
and the Program Supply Voltage
PP
Table 17
decoupled with a 0.1μF
Circuit. The PCB trace
and
PP
IH
Table
is only
, the device is
IL
, the
18).
PP
must
13/69