M28W320FCT70N6F NUMONYX, M28W320FCT70N6F Datasheet - Page 25

• Manufacturer Part Number: M28W320FCT70N6F
• Description: IC FLASH 32MBIT 70NS 48TSOP
• Manufacturer: NUMONYX

Specifications of M28W320FCT70N6F

• Format - Memory: FLASH
• Memory Type: FLASH - Nor
• Memory Size: 32M (2M x 16)
• Speed: 70ns
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-TSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

5
5.1
5.2
5.3
Block locking
The M28W320FCT and M28W320FCB feature an instant, individual block locking scheme
that allows any block to be locked or unlocked with no latency. This locking scheme has
three levels of protection.
The protection status of each block can be set to Locked, Unlocked, and Lock-Down.
Table 10
Figure
Reading a Block’s Lock Status
The lock status of every block can be read in the Read Electronic Signature mode of the
device. To enter this mode write 90h to the device. Subsequent reads at the address
specified in
represented by DQ0 and DQ1. DQ0 indicates the Block Lock/Unlock status and is set by the
Lock command and cleared by the Unlock command. It is also automatically set when
entering Lock-Down. DQ1 indicates the Lock-Down status and is set by the Lock-Down
command. It cannot be cleared by software, only by a hardware reset or power-down.
The following sections explain the operation of the locking system.
Locked state
The default status of all blocks on power-up or after a hardware reset is Locked (states
(0,0,1) or (1,0,1)). Locked blocks are fully protected from any program or erase. Any
program or erase operations attempted on a locked block will return an error in the Status
Register. The Status of a Locked block can be changed to Unlocked or Lock-Down using the
appropriate software commands. An Unlocked block can be Locked by issuing the Lock
command.
Unlocked state
Unlocked blocks (states (0,0,0), (1,0,0) (1,1,0)), can be programmed or erased. All unlocked
blocks return to the Locked state after a hardware reset or when the device is powered-
down. The status of an unlocked block can be changed to Locked or Locked-Down using
the appropriate software commands. A locked block can be unlocked by issuing the Unlock
command.
Lock/Unlock - this first level allows software-only control of block locking.
Lock-Down - this second level requires hardware interaction before locking can be
changed.
V
and erase on all blocks.
PP
22, shows a flowchart for the locking operations.
defines all of the possible protection states (WP, DQ1, DQ0), and
V
Table
PPLK
- the third level offers a complete hardware protection against program
6, will output the protection status of that block. The lock status is
Appendix
C,
25/69